Dregs Container - Siemens TQ507DF3 User Manual

en Cleaning and servicing
Clean the brewing unit thoroughly
6.
under warm running water.
→ Fig.
23
Clean the appliance interior with a
7.
damp cloth and remove any coffee
residues.
Leave the brewing unit and the appli-
8.
ance interior to dry.
Hold the brewing unit by the handle.
9.
Push the red lever upwards.
10.
Position the brewing unit under the
11.
lever and slide it back as far as it will
go.
→ Fig. 24
a The lever will click into place.
Insert the drip tray with the coffee
12.

dregs container.

→ Fig.
25
Close the door.
13.
→ Fig.
26
The door can only be closed if the
brewing unit and drip tray are inser-
ted correctly.
Service programmes
After certain time intervals, your appli-
ance will recommend that you use the
service programmes. Use the service
programmes to clean your appliance
thoroughly.
ATTENTION!
Improper cleaning and descaling or a
delay in doing so may damage the ap-
pliance.
▶
Immediately perform the descaling
process in accordance with the in-
structions.
▶
Do not put any descaling tablets or
other products into the ground cof-
fee compartment.
Depending on the water hardness and
use of the appliance, the display will
show the following messages after
prior notification:
¡ "Please rinse milk system."
74
¡ "Descaling necessary. Please press
menu for 3 sec."
¡ "Cleaning necessary. Please press
menu for 3 sec."
¡ "calc'nClean nec. Please press
menu for 3 sec."
Notes
¡ The display indicates the progress of
the descaling or cleaning process.
¡ If your appliance is not descaled in
good time, the display will show the
following message: "Descaling over-
due. Appliance is locked. Please
press menu for 3 sec.".
¡ If your appliance has been locked,
you can only operate it again once
the descaling process has been car-
ried out.
¡ If you accidentally interrupt the ser-
vice programme, you must reset it.
→ "Resetting service programmes",
Page 74
Tips
¡ If you use a water filter, this prolongs
the time interval until a service pro-
grammes needs to be performed.
¡ You can combine the cleaning and
descaling programmes using the
calc'nClean service programme.
→ "Using calc'nClean", Page 76
¡ Clean your appliance with a soft,
damp cloth immediately after a ser-
vice programme to remove any de-
scaling solution residues and pre-
vent corrosion.
Resetting service programmes
Perform the following steps if a service
programme is interrupted, e.g. due to a
power failure.
Rinse out the water tank.
1.
Fill the water tank with fresh, non-
2.
carbonated water up to the "max"
marking.
Press ⁠ .
3.
a The appliance will rinse itself for ap-
prox. 2 minutes.