Sanotechnik SanoSpa SPA08 Programming Instructions Manual page 50

Hide thumbs Also See for SanoSpa SPA08:
Table of Contents

Advertisement

Available languages

Available languages

(1)
Press "
display, Mark of "CYCLE" is flasfed, In the same time, The Circulation-cleaning start
time setting is oning. Press "
without save.
(2)
Press "
will add 1 minute when pressing "
thecontinually when pressing the "
It will add 1 hour when pressing "
continually when pressing the "
you set up well of the start time , you could go on to the next step.
(3)
Press "
minimum continue time is 5 minutes on the LCD, and this time will not flash. It will add 5
minutes by pressing "
please note that the maximum of continual time is 19 hours and 55 minutes. When you
set up well of the continual time , you could go on to the next step.
(4)
When everything is setting well, Press "
cleaning setting status with save.
NOTICE
1.
all setting of Circulation-cleaning must be in Waitting mode status.
2.
Circulation PUMP and OZONE are not working while all setting time.
5.
Pre-heating setting:
Only one pre-heating setting is allowed each day. The LCD can show clearly in the following
figures about whether pre-heating setting status are ON or OFF.
Fig.7: Pre-heat ON
Pre-heating setting is in the "Waitting Mode" status and the LCD display "- - -".
(1)
Press "
"PREHEAT" mark is flashed, In the same time, The Preheat start time setting is oning.
Press "
50
",and enter to Circulation-cleaning setting status, and "
"and "
" can change the start working time of Circulation-cleaning: It
" to continual working time setting of Circulation-cleaning, it will show the
" each time, And add 1 hour by pressing "
Fig.8: Pre-heat OFF
",and enter to Pre-heating setting status, "ON" of the LCD display, The
" again, The Preheat setting will quit in without save.
PROGRAMMING INSTRUCTIONS
"again, The Circulation-cleaning setting will quit in
" each time and the minutes could be added
" without stop. The adjustment range is 0~59.
" each time, and the hours could be added the
" without stop. The adjustment range is 0~23. When
", the system will quit the Circulation-
"of the LCD
" each time.

Advertisement

Table of Contents
loading

Table of Contents