Table of Contents
Advertisement
It is recommended to use "S" twist thread in the left needle (Viewed from front), and "Z" twist thread in the
right needle.
V\linding amount
adjusting screw
0
Even winding with
an amount 4/5 of
fully capacrty
Fig.5
When discriminate use of needle thread is impossible, use "Z" twist thread in the needle. For bobbin thread,
"S" twist thread as well as "Z" twist thread can be used.
4. How to route the upper thread (Fig.7, Fig.8):
1) Pass each upper thread through thread guide A
Note: when thin slippery thread (polyester thread for example) is used pass the thread through thread
guide B as show in Fig. 7
2) With the take-up lever located at the upper most position, pass each thread in the order in Fig.8.
Note: Pressing the upper thread loosening button, the upper
thread can be pulled out easily.
A B A B
A
Needle thread
tension releasing button
Lead the
Lead the
thread
thread
leftward
rightward
5. Adjustment of stitch length and reverse sewing (Fig.9):
1) Rotate the stitch length adjusting dial to change the stitch length
- 3 -
Fig.8
Advertisement
Table of Contents
