Engine Oil - Scag Power Equipment V-TIDE II SVRII-32A-16FX Operator's Manual

Section 7
DRAIN PLUG
Figure 7-3. Hydraulic Oil Filter
C. CHANGING HYDRAULIC OIL FILTER
ELEMENT
The hydraulic oil filter should be changed after every 500
hours of operation or annually, whichever occurs first.
1. Remove the oil filter element. See Figure 7-3.
Properly discard the oil filter element. Fill the new
filter with clean oil and install the filter. Hand tighten
only.
2. Run the engine at idle speed with the speed control
lever in neutral for five minutes.
3. Check the oil level in the hydraulic tank. Hydraulic oil
must be at least 2-1/4" inches from top of the filler
neck. If the level cannot be determined visually, use
a clean tape measure to check the level. If the fluid
is low, add 20W50 oil (Scag p/n 486255 - 1 Quart or
p/n 486254 - 1 Gallon).

7.4 ENGINE OIL

A. CHECKING ENGINE CRANKCASE OIL LEVEL
The engine oil level should be checked after every 8 hours
of operation or daily as instructed in the Engine Operator's
Manual furnished with this mower.
B. CHANGING ENGINE CRANKCASE OIL
After the first 20 hours of operation, change the engine
crankcase oil and replace the oil filter. Thereafter,
change the engine crankcase oil after every 100 hours of
operation or monthly, whichever occurs first. Refer to the
Engine Operator's Manual furnished with this mower for
instructions.
FILLER & DIPSTICK
HYDRAULIC OIL
FILTER
C. CHANGING ENGINE OIL FILTER
After the first 20 hours of operation, replace the engine oil
filter. Thereafter, replace the oil filter after every 200 hours
of operation or every month, whichever occurs first. Refer
to Engine Operator's Manual for instructions.
37
ENGINE OIL
Figure 7-4. Drain Plug, Dipstick and Oil Filter
Location
R
ENGINE OIL
FILTER
ENGINE OIL
DRAIN