Table of Contents
Advertisement
●
Only qualified personnel are to perform the installation.
●
Flush unit (through outlet) to drain for 10 minutes at recommended flow
rates prior to use.
●
Install shut off valves on both the inlet and the outlet to isolate unit
while servicing.
●
Plumb drains with appropriate valves to reduce service time.
●
Include a by-pass with shut off valves between the inlet and outlet.
See installation Block Diagram on page 7.
●
Install appropriate pressure gauges into the gauge ports provided.
Model HUR1X170FL outlet pressure gauge is to be installed in-line
and in close proximity to the outlet flange.
●
Install plug or appropriate valve into the vent port provided.
●
Lubricate Swing Bolt Assemblies (all models) & Davit Assemblies
(HUR 3X170FL, HUR 5X170FL & HUR 8X170FL) using Food Grade
grease with PTFE and NSF rated H1 only.
●
Replace cartridge(s) when certain conditions exist.
For example:
●
Spare Parts:
1. Sufficient supply of replacement cartridges.
Note: Harmsco
2. Housing O-ring Seal:
Model #
HUR 1X170FL
HUR 3X170FL
HUR 5X170FL
HUR 8X170FL
3. Optional: Cartridge Lifting Handle, Part #362-L
®
Copyright Harmsco
Inc.
All rights reserved.
1243-HP, MANUAL - HUR FL
®
HARMSCO
Swing Bolt Water Filters
REQUIREMENTS
RECOMMENDATIONS
1. Differential pressure is greater than 30 psi.
2. Quality of water is unacceptable.
3. Flow rate has diminished.
4. Every 6 months
®
Hurricane
include: Activated Carbon, High Temperature, SureSafe
Poly-Mesh, Poly-Pleat
Contact a Harmsco
®
Hurricane
HC/170 filter cartridge specifications.
EPDM (std)
361-E
363-E
365-E
368-E
®
Hurricane
®
HC/170 filter cartridges available
TM
& more.
®
sales representative for Harmsco
Part #
BunaN
361-B
363-B
365-B
368-B
TM
,
®
Viton
361-V
363-V
365-V
368-V
Page 4 of 25
Advertisement
Table of Contents
