Calibrating The Temperature Sensor; Troubleshooting - Aprilaire 8710 Safety & Installation Instructions

CALIBRATING THE TEMPERATURE
23
SENSOR OFFSET
Typically, it is not necessary to adjust the temperature
calibration offset from the factory setting. If calibration is
necessary, a high quality electronic digital thermometer
must be used. Place the thermometer sensor probe next
to the thermostat sensor and allow five minutes before
comparing the temperature readings.
Press the NEXT key to select
Up or Down keys to adjust the temperature calibration
offset. Press ENTER key to save the options and return
to normal thermostat operation.
Option
CANCEL
Option 16 and use the
Inside
NEXT
ENTER
TROUBLESHOOTING THERMOSTAT
24
AND CONTROL MODULE LINKING
Need to terminate control module linking
The control module blinks red/yellow when waiting to be
linked with a thermostat. To terminate the linking
process in the module, either remove power to the
module and then power back on or wait about six
minutes for it to time out. LED will blink green. The
control module retains its home and zone number.
Relink to a thermostat if necessary
Changed Zone or Home number but didn't complete
linking sequence
If necessary, terminate control module linking outlined
above. Relink the thermostat and control module by
starting the linking process outlined on page 8 and link
the units by using options 1, 2 and 3 outlined on pages
10 and 11.
Mistakenly pressed ENTER in Option 03
Relink the thermostat and control module by starting the
linking process outlined on page 8 and link the units by
using options 1, 2 and 3 outlined on pages 10 and 11.
Not sure what thermostat goes with what module
Relink each thermostat and control module set by
starting the linking process outlined on page 8 and link
the units by using options 1, 2 and 3 outlined on pages
10 and 11.
18