ATD Tools ATD-7433A Owner's Manual page 3

ASSEMBLY
to 1
1. Three ma or parts should
unit with pumpi
saddle unit
pieces of ase half with
. Attach one of the
raulic unit, then secure usin allen head olts and
washers provided. Then
the other half. Use torque wrench to
30 l . torque. Do not overt hten.
3. Attach the ts to the reservoir, then attach one end
of the support to ase half and the other end to the
. Secure with
for all other three support ars.
4. Slide the position handle to the reservoir from top, then
secure with and nuts provided.
. the saddle unit
the saddle onto the ram piston. Secure usin
the set screw.
!
WARNING
Study, understand, and follow all printed materials
provided with/on this product before use.
Do not exceed rated capacity.
Use only on hard, level surfaces capable of
supporting rated capacity loads.
Use of this jack is limited to the removal, installation
and transportation of transmissions, transfer cases
and transaxles. Do not use a transmission jack to
tilt or support a vehicle.
Ensure the center gravity of load is centered on the
saddle.
Do not exceed 10˚ tilt angle of the saddle assembly
in all directions.
Adequately support the vehicle before starting repairs.
Use only chains and slings provided.
If loaded jack must be moved, make sure that the
load is secured, stable and in lowest position.
This is a lifting and lowering device only.
Transfer load immediately to appropriate support
device for service or repair.
No alterations shall be made to this product
Failure to heed these markings may result in
personal injury and/or property damage.
included in pa
mechanism
ts and washers
halves to the of the
the same procedure to
ts and nuts provided. epeat
the ram piston, place
BEFORE USE
1. Inspect
or crac d components are noted. nsure that casters
move freel . Chec for and
. Verif that the product and the application are compati le.
air in the reservoir.
4. sure oil level is ust
hole. tall the oil filler screw
to
Raise Saddle:
1. ump foot pedal or press air pump pedal until
saddle reaches desired position.
. vehicle manufact
procedures for r
service manual or repair
3. Secure load with provided chains.
4.
and load is st
Lower Saddle:
CAUTION!
loweri load.
Slowl , e
pedal.
3
each use. Do not use if
hten
low the rim of the oil filler screw
recommended
the load as outlined in vehicle
.
s center of vi is centered on the saddle
movi
sure all tools and personnel are clear efore
downward pressure to the release valve
!
WARNING
To avoid crushing and related
injuries:
NEVER work on, under or
around a load supported only
by a jack. Immediately
transfer the load to an
appropriate work station.
n
loose es.