MOPEKA Pro Sensor Quick Start Manual page 7

Aluminum Tanks:
20. The sensor mounts to the bottom center of the tank using the collar set.
21. The collar set has pre-applied 2-sided adhesive. The tank must be properly prepared or the collar will not
adhere.
22. The tank must be thoroughly cleaned with soap and water.
23. Allow the water to dry, then clean the tank with an alcohol pad or similar, to remove all grease.
24. Lay the collar set in the center of the tank bottom, and mark as needed to guide the final installation of
the collar onto the tank.
25. Separate the collar pieces, peel the backing paper from the base piece, and stick to the tank per your
markings. Thoroughly press the ring all the way around. Pressure is required to force the tape to adhere
to the tank.
26. Apply a generous amount of the supplied sonic grease directly to the rubber pad before attaching sensor
to the tank.
27. Install sensor inside the collar, rubber pad against tank.
28. Now snap the retaining ring onto the collar set.
www.mopeka.com
Page 7 of 14
M200004E