Table of Contents
Advertisement
User Manual: V PRO-OEM
emergency switch is connected use the 9 pin plug
supplied.
6
Security switch: Laser on/off
7
ILDA connector in/out
8
Power switch: power on/off
9
Power: connect to mains.
Control panel
•
MODE: select mode, or go up in menu
•
ENTER: confirm changes, or go down in menu
•
UP/ DOWN: change DMX address
Operating modes:
Automatic mode: built-in patterns are displayed
Music active: laser is controlled from built-in microphone
"DMXAddr": DMX512 mode-. Here you can change the DMX address:
"Open": change address
"Up" & "down": increase/decrease address
"Save": save new address
"LCD display memory function":
Laser: On/Off, when set to Off, laser is off in Auto/DMX mode (ILDA mode only)
X/Y-Axis: mirrors projection horizontally/vertically
Upside down: Display turned upside down
ILDA mode
When an IDLA compatible interface is connected to the laser, the laser is automatically
switched to ILDA mode. Output is then controlled from a PC running software.
The laser uses pins 4 and 17 of the IDLA signal to detect the presence of an ILDA interface.
Further information can be found in the software manual.
DMX mode
Channel
1
2
3
4
5
save settings automatically.
DMX512 value
Red
Green
Blue
Colour
Pattern group
0~255
0~100% Dimmer
0~255
0~100% Dimmer
0~255
0~100% Dimmer
0~25
Original colour
26~51
White
52~77
Yellow
78~103
Red
104~129
Green
130~155
Cyan
156~181
Blue
182~207
Purple
208~233
Change colour
234~255
Colour flux, slow to fast
0~51
Pattern group 1
52~103
Pattern group 2
104~154
Pattern group 3
155~205
Pattern group 4
206~255
Pattern group 5
Page 4 of 8
Function
Stand: 03/2010
Advertisement
Table of Contents
