Installation - Defiant DFI-5998-BK Use And Care Manual

Installation

1
Determining the mounting
location
NOTE: The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground. If the light fixture is
mounted higher than recommended, aiming the sensor
down will reduce the coverage area.
□
Determine the mounting location – wall mount
only.
□
Position the lamp heads (A) in the general
direction of the desired light coverage.
2
Drilling canopy holes
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
□
Remove the existing light fixture.
□
Determine which of the four knockouts need to
be drilled to match the mounting holes on the
junction box.
□
Drill the necessary holes into the light
fixture canopy (B) using a drill (not included)
and a 3/16" (5 mm) drill bit (not included).
B
Wall Mount
3
Wiring the light fixture
□
Connect the light fixture (B) wires to the
junction box wires with wire connectors (AA):
□
White to white
□
Black to black
AA
5
Please contact 1-866-308-3976 for further assistance.
A
UP
HOMEDEPOT.COM
B