3. DISASSEMBLy AND REASSEMBLy
3-1. TOOLS FOR REMOvAL AND REASSEMBLy
Tool image
No.
Adjustable Wrench
➊
Open-end Wrench
➋
➌
➍
(screwdriver, nipper, long nose pliers)
Nut Driver
➎
* Preparation for parts replacement
1. T ake out the residual water inside the product.
(Drain the water by operating the drain pump)
2. Close the water supply valve.
3. T urn off the power & disconnect power cable.
You must turn off the circuit breaker connected to the product.
4. P ull out the unit from the sink and lay it on the floor.
Be careful of the drain hose when pulling out the unit.
Caution
When pulling out or laying the dishwasher down for service, it may be necessary to lower the height of the adjustable
legs to provide the clearance for the removal of the unit, prevent breaking the legs, or damaging the base of the unit.
Tool
Type
1-7/16"
Vice pliers
Others
10mm
Leg
Common tools for servicing
Screwdriver - Philips, flat, Torx T
Heater bracket Nut
Disassembly and Reassembly _ 9
Remarks
15