Table of Contents
Advertisement
HStab and Elevator
Cut the sticks to length, according to the printed plans,
then lay the laser cut parts out on the plans, fitting the
sticks into the pre-cut slots. After the entire assembly
is dry-fitted you may glue the parts together.
For the elevator, cut the sticks to length, according to
the printed plans, then lay the laser cut parts out on the
plans, fitting the sticks into the pre-cut slots. After the
entire assembly is dry-fitted you may glue the parts
together. Glue the tri-stock to the leading edge of the
elevator and NOT to the trailing edge of the HStab.
HStab, Elevator and Rudder Build
As with the other tail surfaces, cut the sticks to length,
according to the printed plans, then lay the laser cut
parts out on the plans, fitting the sticks into the pre-cut
slots. After the entire assembly is dry-fitted you may
glue the parts together. The VStab is a simple, single
laser cut part of ¼ inch thick wood as shown in the
picture. This part is NOT glued to the rudder. It is
glued to the fuselage after it is covered to provide a
hinge-point for the upper part of the rudder.
Glue the tri-stock to the leading edge of the rudder and
NOT to the trailing edge of the fuse.
8
Rudder
Advertisement
Table of Contents
