Table of Contents
Advertisement
th
Using 1/16
sheeting, sheet the center section of the
wing. The grain should run the length of the cord,
except for the leading edge, which runs span wise for
easy bending around the leading edge. Cut the wing
sheeting parts from the center of the fuse sheeting
laser cut parts.
To get the sheeting to bend around the leading edge
of the wing you will need to dampen the wood with
water. Do not soak the wood, but take a wet
washcloth and dampen it until it will easily bend
around the leading edge. I joined the upper and
lower sheets at the center of the leading edge.
As shown in the above picture, add the plywood servo
mounts, just aft of the battery box, yet flush with the
center section sheeting. You might need to trim away
some of the sheeting that overhangs the rib.
The servo mounts are plywood and have 2
plywood triangle supports for each. Make sure
you don't forget to use the triangle supports. If
using standard size servos, use the larger mounts.
If using mini servos, use the smaller mounts.
6
Advertisement
Table of Contents
