Advertisement
7
Configuring IP Addresses via Web Interface
Set your PC Address the same network segment as the default IP address
(192.168.0.200). Key in the default iCAM IP address in the web browser
and follow the steps below:
1. Login to the iCAM by key in the default username "admin" and
password "pass".
2. When log in, click upper right "Setup" to get to following capture page
3. Click "Network" and get into "General"
4. Set the IP address, Subnet Mask, and Gateway to the required one
5. Click Submit to verify all settings.
8
Configuring IP Addresses with IPScan Software
【OR】To change the settings of the IP address, Subnet Mask, Gateway,
or etc., you can follow the steps below:
1. Run IPScan Software (or other IP Scanner software is accepted)
2. Click Refresh/Scan. All available devices should be shown in the list
3. Click to set the IP address, Subnet Mask, Gateway to the required one
4. Click Apply to confirm the settings and verify settings.
P.7
Advertisement
