Advertisement
4
Reset to Factory Defaults
Reset the hardware to factory defaults, please follow these steps:
1. Press and hold "Factory default button" for more than 10 seconds
until the Len LED flashes once, then release the button.
2. Wait for 40 seconds, then the network LED light will turn off, and
go back on again.
3. The camera is now restored to factory defaults, and will auto reboot.
4. Search for the device IP using the IPScan software. Remember to
check the items "ONVIF" & "ONVIF Deep Scan".
5. Use a web browser to open this device IP.
6. Enter default username "admin" and password "pass" to operate.
Note: Reset to the factory defaults will restore to the default IP address: 192.168.0.200
5
Before Accessing IP Cameras
Before accessing the IP camera, make sure that the camera's RJ-45 network,
audio, and power cables are properly connected. To set the IP address,
consult your network administrator for an available IP address. The default
IP address for each IP camera is 192.168.0.200. Users can use the default
IP address for verifying the camera's network connection.
6
Software Requirements
When login to the IP camera by
Internet Explorer, the pop-up box
will prompt (OS Win10 excluded)
the installation of the Universal
ActiveX. Click Install to download it.
P.6
Advertisement
