FXSQ-PAVE EDFMT391737 • When wiring between the indoor and outdoor units, and • Make sure to provide for adequate measures in order to prevent wiring the power supply, form the wirings orderly so that the that the outdoor unit be used as a shelter by small animals.
Page 50
FXSQ-PAVE EDFMT391737 CARRY OUT THE WORK GIVING CAUTION • Do not use the air conditioner in a salty atmosphere such as coastal areas, vehicles, vessels or where voltage fluctuation TO THE FOLLOWING ITEMS AND AFTER THE is frequent such as factories.
FXSQ-PAVE EDFMT391737 [ Required installation space ] If you set the fan speed at thermostat OFF, did you Figures indicate the minimum required installation space. explain the set fan speed to the cus tomer. Have you handed the operation manual and the...
FXSQ-PAVE EDFMT391737 (2) Use hanging bolts for installation. Control box Investigate if the installation place can withstand the mass of the indoor unit and, if necessary, hang the indoor unit with bolts after it is reinforced by beams etc. Ceiling 4.
FXSQ-PAVE EDFMT391737 5. INSTALLATION OF INDOOR UNIT In addition, adjust clearance (50 - 100 mm) from the ceil- ing in advance. Depending on the optional parts, it may be easier to attach them before installing the indoor unit. Refer to also the <Installation examples>...
FXSQ-PAVE EDFMT391737 Torque wrench CAUTION • Install the indoor unit leveled. Spanner If the indoor unit is inclined and the drain piping side gets high, it may cause malfunction of switch and result in water leakage. • Attach nuts on the upper and lower side of hanger.
FXSQ-PAVE EDFMT391737 • After leak test, referring to Fig. 11, insulate both the gas • Before brazing refrigerant piping, have nitrogen and liquid piping connection with the attached joint in- through the refrigerant piping and substitute air with nitro- sulating material (4) and (5) to prevent the pipings from gen (NOTE 1) (Refer to Fig.
Page 56
FXSQ-PAVE EDFMT391737 1~1.5 m <In case of sticking vinyl tape> Tightened part Support Downward inclination of 1/100 or more Good Vinyl tape Stick vinyl tape without tearing the sealing material (Large) (6). Wrong <In case of bending the tip> Fig. 13...
Page 57
FXSQ-PAVE EDFMT391737 • If a person is not present, after the electric wir- CAUTION ing work is check the drainage accord ing to the • To avoid the attached drain hose (2) getting excessive in [When the electric wiring work is method force, do not bend nor twist it.
Page 58
FXSQ-PAVE EDFMT391737 8. DUCT WORK 9. ELECTRIC WIRING WORK Pay the utmost attention to the following items and 9-1 GENERAL INSTRUCTIONS conduct the ductwork. • Make certain that all electric wiring work is carried out by • Check that the duct is not in excess of the setting range of qualified personnel according to the applicable legislation...
Page 59
FXSQ-PAVE EDFMT391737 • Connect the terminal as shown in Fig. 22. FXSQ20PAVE 0.078 • Do not carry out soldering finish when stranded wires are FXSQ25PAVE 0.078 used. (Otherwise, the loosening of wires may result in abnormal heat radiation.) FXSQ32PAVE 0.078 FXSQ40PAVE 0.130...
Page 60
FXSQ-PAVE EDFMT391737 (2) Connect the wiring into the control box through the (5) Securely each wire with the provided clamp mate- wiring intake beside the control box. rial (8). Wiring intake Wiring intake Clamp (8) (high voltage) (low voltage) (accessory)
Page 61
FXSQ-PAVE EDFMT391737 < No. 2 system: When carrying out group control or 2 Terminal block remote controller control. > (X2M) Power supply 220-240 V Terminal for remote 50 Hz controller wiring (P1, P2) No polarity 220 V Outdoor Note) It is not needed to set the...
Page 62
FXSQ-PAVE EDFMT391737 10. FIELD SETTING Return to the “Basic screen” (“Normal mode” if a wireless remote controller is used), and press the ON/OFF button. The operation lamp is lit, and the indoor unit will go into fan CAUTION operation for air volume automatic adjustments (at which Before carrying out field setting, check the items mentioned in...
Page 63
FXSQ-PAVE EDFMT391737 10-2 SETTING WHEN AN OPTIONAL ACCESSORY IS 11. TEST OPERATION ATTACHED • After cleaning the indoor unit inside, carry out test operation • For setting when attaching an optional accessory, refer to the according to installation manual attached to the outdoor unit.
Page 68
VRV is a trade mark of Daikin Industries, Ltd. VRV Air Conditioning System is the world’s first individual air conditioning system with variable refrigerant flow control and was commercialised by Daikin in 1982. VRV is the trade mark of Daikin Industries, Ltd., which is derived from the technology we call “variable refrigerant volume.”...
Need help?
Do you have a question about the FXSQ-PAVE and is the answer not in the manual?
Questions and answers