Table of Contents
Advertisement
en Cookware test
Display
Setting
Power limitation
This makes it possible to limit the total power
of the hob in accordance with the require-
ments of the specific electrical installation. If
the function is active and the hob has
reached the set power limit,
and you cannot select a higher power level.
The available settings depend on the max-
imum power of the hob, which is specified
on the rating plate.
Selected time for the hotplate
Cookware test
Result of the cooking process
Restoring factory settings
1
Factory setting
11.2 To go to the basic settings
Requirement: The hob must be switched off.
To switch on the hob, touch
1.
Within the next 10 seconds, press and hold
2.
four seconds.
Product information
Directory for the technical after-sales
service (TK)
Production number
Production number 1
Production number 2
a The first four displays provide the product informa-
tion. Touch
or
to view the individual displays.
12
Cookware test
The quality of the cookware has a major influence on
the speed and the result of the cooking process.
You can use this function to test the quality of the cook-
ware.
Before the test, ensure that the diameter of the cook-
ware base corresponds to the diameter of the cooking
zone being used.
Access is via the basic settings. → Page 9
12.1 Procedure for checking the cookware
Set the cookware at room temperature with approx.
1.
200 ml water in the centre of the cooking zone
whose diameter best fits the diameter of the base of
the cookware.
Call up the basic settings and select .
2.
Touch or . The
3.
zones.
a The function has been activated.
a After 10 seconds, the result appears in the cooking
zone displays.
10
is displayed
.
Display
.
.
display flashes in the cooking
Value
- Switches off the hob's maximum power
- 1000 W Lowest power setting
- 1500 W
...
- 3000 W Recommended for 13 A
- 3500 W Recommended for 16 A
- 4000 W
- 4500 W Recommended for 20 A
...
- Maximum power of the hob
Unlimited: The hotplate that was set last remains selec-
1
ted
.
- Limited: The hotplate only remains selected for a few
seconds.
- Not suitable.
- Not optimal.
- Suitable.
- Individual settings
- Factory settings.
Touch
3.
a
and
light up alternately as well as as a preset
value.
Touch
4.
for
pears.
Use
or
5.
Touch and hold
6.
a The settings are saved.
11.3 Exiting the basic settings
To exit the basic settings and and switch off the
▶
hob, touch
12.2 Checking the result
In the following table, you can check the result for the
quality and speed of the cooking process:
Result
1
If a smaller cooking zone is available, test the cook-
ware on this cooking zone.
Touch or
1
.
to access the basic settings.
repeatedly until the desired setting ap-
to select the required value.
for four seconds.
.
The cookware is not suitable for the
cooking zone and therefore does not
1
heat up.
The cookware is taking longer to heat
up than expected and cooking is not
progressing as well as it ought to.
The cookware is heating up correctly
and cooking is progressing well.
to activate the function.
1
1
Advertisement
Table of Contents
