Related Manuals for Bakers Pride DANTE Series
Summary of Contents for Bakers Pride DANTE Series
- Page 1 DANTE SERIES GAS CHARBROILER GLO-STONES/RADIANT C, F, L Installation and Operation Instructions 2M-Z24018 Rev. A 05/21...
- Page 2 WARNING (ASAP) companies, this warranty will be void. In addition, Bakers Pride and its affiliates will not be liable for any claims, This appliance is intended for professional use only and damages or expenses incurred by the customer which arises should be operated by fully trained and qualified personnel.
-
Page 3: Table Of Contents
TABLE OF CONTENTS AUSTRALIAN ADDENDUM TO L25-001 R3 INSTALLATION GAS HOOK UP GAS SETTINGS LIGHTING INSTRUCTIONS BROILER SHUT DOWN GLO-STONES C, F, L MODELS WITHOUT SAFETY PILOT BROILER SHUT DOWN RADIANT C, F, L MODELS WITH SAFETY PILOT GLO-STONES C, F, L MODELS WITH SAFETY PILOT INITIAL SET-UP RADIANT C, F, L MODELS GLO-STONES C, F, L MODELS... -
Page 4: Australian Addendum To L25-001 R3
AUSTRALIAN ADDENDUM TO L25-001 R3 This appliance must be installed to the requirements of AS/NZS5601.1, local gas and electric authority and any other relevant statutory regulations. The appliances covered by this manual are for use only with the gas type displayed on the data plate. -
Page 5: Installation
INSTALLATION Units are to be installed in non-combustible locations only to utilize a 0” (0 mm) minimum clearance to non- combustible construction. Not approved for installations in combustible constructions. In North America this installation must conform to local codes. In the absence of local codes, the installation must conform with the National Fuel Gas Code, ANSI Z223.1: Natural Gas Installation Code, CAN/CGA B149.1;... -
Page 6: Gas Hook Up
GAS HOOK UP An adequate gas supply is imperative Undersized lines or low-pressures will restrict the volume of gas required for satisfactory performance. A steady supply pressure between 7’’ and 8’’ w.c. (1.75 and 2 kPa) for natural gas or 11’’ to 12” w.c. (2.75 to 3.0 kPa) for propane gas is required. With all gas appliances operating simultaneously, the manifold pressure on any appliance should not show any appreciable drop. -
Page 7: Gas Settings
GAS SETTINGS Regulator pressure must be measured and adjusted before the unit goes into service, following installation and when operational performance is in question. A soft blue flame, just short of a yellow tip, gives the best results; combustion air can be adjusted by opening or closing the air shutter slightly. LIGHTING INSTRUCTIONS: Regulator pressure must be measured and adjusted before the unit goes into service, following installation and when operational performance is in question. -
Page 8: Glo-Stones C, F, L Models Without Safety Pilot
GLO-STONES C, F, L SERIES MODELS WITHOUT SAFETY PILOT A. Turn all burners to OFF. B. Remove the top grid(s). C. Turn the runner tube valve to ON. D. Light the runner tube through the gap in the front of the coal support as shown. (Note: If the runner tube does not light, wait a few seconds, then try again.) E. -
Page 9: Radiant C, F, L Models With Safety Pilot
F. Wait an additional 15-30 seconds. Release the reset button. The runner tube should remain lit. (NOTE: If the runner tube fails to ignite, repeat step 5. If the runner tube fails to ignite after three attempts, contact an authorized Bakers Pride service agent.) G. Replace the radiant and top grid. -
Page 10: Initial Set-Up
INITIAL SET-UP All Models PROPER SET UP OF THE BROILER - After the installation of the broiler by a qualified technician, a thorough cleaning is necessary. After this cleaning, be sure the broiler is set up properly. TOP GRID - Your top cooking grid has two positions, either flat or tilted. Whenever you are broiling, you must use the tilted position. -
Page 11: Radiant C, F, L Models
RADIANT C, F, L SERIES MODELS STAINLESS STEEL RADIANT - It is very important that the stainless steel radiants are placed over the burners. This will provide radiant heat and protect the burners from dripping grease. PREHEATING - It is necessary to preheat a cold broiler each time before cooking. The recommended time is 3-5 minutes for radiant style charbroilers, at which time the cooking grid should be hot enough to cook on without sticking, and will produce the proper searing effect. -
Page 12: Glo-Stones C, F, L Models
COALS - Use only Glo-Stones supplied by Bakers Pride. Do not use lava rock or other replacement coals. They do not perform as well or last as long as the Glo-Stones that were designed for this application. Place the coals evenly across the surface of the coal support. -
Page 13: Cleaning And Maintenance
The rods need only be scraped free of all cooking debris, especially the underside of the rods, using the Bakers Pride scraper provided. The light oily sheen will aid in cooking, acting like a seasoned iron skillet. -
Page 14: Typical Radiant C, F, L Illustration
TYPICAL RADIANT C, F, L SERIES ILLUSTRATION NOTE: Your unit may vary from this typical diagram. Model C-36 Shown... -
Page 15: Typical Glo-Stones C, F, L Series Illustration
TYPICAL GLO-STONES SERIES ILLUSTRATION NOTE: Your unit may vary from this typical diagram. Model C-36 Shown... -
Page 16: Accessory/ Parts List For Radiant/ Glo-Stones C, F, L Series Models
ACCESSORY/ PARTS LIST FOR RADIANT / GLO-STONES C, F, L SERIES MODELS Not all parts are illustrated, nor are all parts are listed. If you need a part that is not listed here, call Bakers Pride for a quote. Always have your model and unit serial numbers available when phoning or ordering. -
Page 17: Warranty
Baker's Pride sole obligation under this warranty is limited to either and proper use and maintenance service as specified by Bakers Pride repair or replacement parts, subject to the additional and upon proper installation and start-up in accordance with the limitations detailed below. - Page 18 Printed in the U.S.A. • 2M-Z24018 • Rev. A 05/21 Specifications are subject to change without notice. 265 Hobson St. • Smithville, TN 37166 is a registered trademark of Bakers Pride®, A Middleby Company. All rights reserved. Telephone: (800) 527-2100...
Need help?
Do you have a question about the DANTE Series and is the answer not in the manual?
Questions and answers