Electrolux LUC4NF23X User Manual page 15

Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily. You attempted to re-open
Side panels of the appli‐
ance are warm.
There is too much frost
and ice.
Possible cause
The temperature in the ap‐
pliance is too high.
The door is left open.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The FastFreeze function is
switched on.
The compressor starts af‐
ter a period of time.
The appliance is not level‐
led.
the door immediately after
closing.
This is a normal state
caused by operation of the
heat exchanger.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
ENGLISH
Solution
Refer to "Door Open
Alarm" or "High Tempera‐
ture Alarm".
Close the door.
Refer to "Control Panel"
chapter.
Wait a few hours and then
check the temperature
again.
Refer to "Installation" chap‐
ter.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "Closing the door"
section.
Refer to "FastFreeze func‐
tion" section.
This is normal, no error
has occurred.
Refer to installation instruc‐
tions.
Wait at least 30 seconds
between closing and re-
opening of the door.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products
better.
Refer to "Control Panel"
chapter.
15