Elan HR2 Quick Reference Manual
Hide thumbs Also See for HR2:

Advertisement

HR2 Quick Reference Guide
The HR2 allows users to enjoy wireless control of their
using your new HR2 remote control.
You will need the following items which are included in the HR2 kit:
A. Remote
B. Charging Station
C. USB to Mini-USB Cable
D. 16VDC @ 1.5A Power Supply
(2.1mm tip Positive)

Required items not included in HR2 kit:

Computer with g! Connect Pro installed
System Controller*
Optional items Purchased Separately:
2900008 - Additional Battery
HR2CS - Additional Charging Station
* System Controller (HC12 / HC8 / HC6 / HC4) sold separately. Please note: The HR2 requires an HC controller running 5.2 or higher.
Accessing the Mini-USB Programming Port, IR Receiver, and On/Off Switch
Endcap Release Button
The HR2 is shipped with the power switch in the "off" position to conserve
removed and the power switch must be changed to the "on" position. To access the power switch locate the Endcap Release Button on the bottom of the remote.
While depressing the endcap release button pull the endcap away from the body of the remote as illustrated.
located on the right side to the "on" position. (For extended periods of non-use it is recommended to turn the remote off with this switch
to conserve the battery life.) Note the location of the Mini-USB port and IR Receiver. Replace endcap and follow the charging instructions below.
Before configuring, the HR2 m st be fully charged.
u
charge, place the remote in the charging cradle and connect the included power supply to the back of the charging cradle and wall outlet. The
remote display may light up briefly while beginning to charge. It is recommended to place the remote in the charging cradle when not in use.
© ELAN Home Systems 2010 • All rights reserved.
system from any zone in the house. A few simple steps are required prior to
A
Figure 1
2
1
Pull Endcap out while pressing
Endcap Release Button
Figure 2

Charging the Remote

Charge the remote in the included charging cradle for at least 2 hours prior to setup.
B
Mini-USB port
Endcap
the pre-installed
battery life.
Prior to setup the endcap must be
C
D
On/Off switch
On
Off
Move the On/Off power switch
16VDC @ 1.5A
Power Supply
(Included)
Page 1
To

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HR2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Elan HR2

  • Page 1 2900008 - Additional Battery HR2CS - Additional Charging Station * System Controller (HC12 / HC8 / HC6 / HC4) sold separately. Please note: The HR2 requires an HC controller running 5.2 or higher. Figure 1 Accessing the Mini-USB Programming Port, IR Receiver, and On/Off Switch...
  • Page 2 5) Enter the password requested on the HR2 screen using the following numeric buttons in this sequence: 3526 enter. 6) You are now ready to proceed with configuration using g! Connect Pro. Please refer to the HR2 integration note for more details.

Table of Contents