Skytech firegear Outdoors FPB-36L Series Combining Linear Burners

NOTICE: Please be aware that when you are combining two linear burners together it is extremely important to size the
gas line for the total Btu's of both burners together.
The FPB-36L, FPB30L and FPB24L Series fire pits can be combined in various combinations to create a longer length fire
pit look. This is accomplished by removing the extension bracket (Fig. 1) outlined in the drawing above from each linear
burner you are wanting to combine together. The extension bracket has the angled end and is secured with two screws
on each side. Simply remove the screws and slide the extension bracket off from each burner. Butt the two non-pilot
ends of each burner tight together and keep them level to provide the appearance of one long linear burner (Fig. 2).
Figure 1. Side view of burner showing extension bracket.
Cradle Bracket
Figure 2. Top view installation
Combining Linear Burners
Extension Bracket
Cradle Bracket
Cradle Bracket
Butt Ends Together
Cradle Bracket
Butt Ends Together
Cradle Bracket
REV. 4-6-16
6.875" (Min.)