Why Doesn't The Temperature/Humidity Readings On My Station Match The Weather Report; What Does A Reading Of "Hi" Or "Lo" Mean; What Does "No" Mean; Why Does My Temp/Humidity Reading Come And Go - La Crosse Technology S77925 Faqs

• If you change the backlight setting the station will stay on the new setting and will
automatically go back to the auto dim on the next start point.
WHY DOESN'T THE TEMPERATURE/HUMIDITY READINGS
ON MY STATION MATCH THE WEATHER REPORT?
• Your temperature and humidity readings are from your sensor at your location. Your local
reporting station can be miles away so readings will differ.

WHAT DOES A READING OF "HI" OR "LO" MEAN?

• If your outdoor temperature reading shows "HI" or "LO", check that your
• Overpowered or underpowered batteries can cause this reading.
• If batteries are good, replace the outdoor sensor.
• If your temperature is fine but your humidity is reading "HI" or "LO" or dashes, your humidity
may be below 10% Relative Humidity. Your sensor does not read below 10% humidity.
• If a sensor loses connection to the station for any reason, the station will show NO after 30
minutes.
• The station will search for 3 minutes every hour to reconnect with sensor.
• Hold the OUT/+ button 2 seconds to search for the sensors in the Outdoor Area
• Icon will flash while searching for sensor. Outdoor area will show dashes during the
search. When sensor is received the icon will be solid.
• If no sensor received, icon disappears after 3 minutes of searching if sensor is not
found.
• NO will again show in the outdoor sensor area.

WHY DOES MY TEMP/HUMIDITY READING COME AND GO?

• RF (radio frequency) communication may come and go occasionally. This can be normal in
some environments (e.g., moister climates).
• If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient
– these stations can reconnect on, after many hours out.
• RF (radio frequency) communication is not always 100% on. Certain temporary conditions
can cause it to go out for a time (e.g., 100% humidity).
If a miss happens:
• If sensor loses connection to the station for any reason, the station will show NO after 30
minutes.
• The station will search for 5 minutes every hour to reconnect with sensor.
• Be sure you have good batteries. Manually search for your sensor.
Try this:
• Bring your sensor within 10 feet of your station and make sure it is connected to the station.

WHAT DOES "NO" MEAN?

batteries are good.
9 | P a g e