Advertisement
Identifying Printer Parts
Unpack the printer and keyboard units and locate on a suitable surface near a mains outlet.
Connect the keyboard & mains adaptor to the printer ( see fig.1 ).
Ensure that the thermal tape & ribbon fig7 are installed ( see also
sections 4 & 5 ).
If you are using die cut tape ensure that the sensor is aligned correctly (see fig 6).
Switch on the printer & the display will illuminate.
fig.1
Rear printer connections
Label roll guide & hub
Die cut tape sensor
fig 4
Printer hood release
fig 3
Calibration
Tape Calibration,
Press & Hold.
Automatically realigns
installed thermal tape to
the sensor.
Check sensor position to
tape if you experience
problems.
Additional Ref.7
Printer with Hood or Printhead open
Additional Reference
pages
Power Button
Press and Hold
Hood lockout / stay
Advertisement
