Download Print this page

Maintaining Your Air Purifier - Shark HE600 Series Owner's Manual

Advertisement

NOTE: Always remove all protective packaging from the filter before installing.
When the filter timer has 0 hours remaining, the FILTER LIFE button on the top control panel will blink, indicating that it's time to install a
new filter.
1. Turn off and unplug the unit before removing or installing filters.
2. Remove the back cover from the unit by pressing the tabs at the
top (1), then pulling the cover toward you.
3. To remove the old filter, pull it out by the tabs at the top and
bottom of the filter (2). Discard old filter in trash.
4. Remove all packaging and wrapping from the new filter.
1
Disposing of used filters
Filters can't be cleaned or recycled. After removing a used filter, wrap it in an airtight plastic bag for disposal. As an extra precaution, wear
gloves when handling a dirty filter.
NOTE: Always unplug the unit before doing any cleaning or maintenance.
Exterior Cleaning:
For best results, clean the exterior of the unit every two months or
as needed. Use a microfiber cloth to remove dust. To sanitize, wipe
down the exterior with a microfiber cloth dampened with warm,
soapy water. Avoid excess water and abrasive chemical cleaners to
prevent damage.
INSTALLING AND REMOVING THE FILTER
5. Insert the new filter, then replace the filter cover. Insert the tabs
6. Plug the unit back in and turn on power. Calibration will begin.
7. After installing a new filter, press and hold the Filter Life button
2

MAINTAINING YOUR AIR PURIFIER

Interior Cleaning:
For best results, clean the interior of the unit every two months
or as needed. Remove the filter cover, take out the filter, and
use a vacuum cleaner or a microfiber cloth to remove dust and
debris from the interior of the unit. DO NOT use abrasive chemical
cleaners on the inside of the unit.
on the bottom of the cover into the slots on the unit (3). Press
the top of the cover, then the sides, until it clicks into place.
on the top control panel for 3 seconds to reset the timer. The unit
will beep when the timer is activated.
3
Remove
filter
from
plastic
packaging

Advertisement

loading