Table of Contents
Advertisement
4.13 Auto-Loading Function
This printer has a function to automatically set the paper. If the paper end sensor,
near paper end sensor, and head-up lever are cancelled, the paper will be
automatically fed by a constant amount in about 1 second.
In order to smooth operation, cancel the head-up mechanism last.
Also, you can use the DIP switch to enable/disable the function. If disabled, auto-
loading will not be performed.
CAUTION:
• When auto-loading is being activated, do not touch the paper roll, because it could
result in a paper feed failure or cause the paper to be one-sided.
• Be sure to set the paper until it comes into contact with the platen roller; otherwise,
the paper cannot be fed and the printing head could be damaged.
4.14 Self-Print Function
This printer has a function to perform preset printing. Turn on the power with the
FEED switch held down. It will print the ROM version, DIP switch state, characters
used, kanji, etc. After self-printing is completed, the printer restores its normal
operating conditions.
CAUTION:
• Do not use this function when the paper roll is running out.
• Data communication cannot be done during self-printing.
— 27 —
Advertisement
Table of Contents
