Table of Contents
Advertisement
(1) POWER switch
Turns on/off the power for the printer body.
(2) POWER lamp (Green/Red)
Comes on in green when the POWER switch is set to ON.
This light is lit in red while the battery is charging, and goes off when it is fully
charged up.
(3) ERROR lamp (Red)
Illuminated at the time of a head-up mechanical error, and blinks at the time of
starting a macro.
(4) PAPER lamp (Red)
Illuminated when the paper is running out (when there is little paper left), and
blinks when a label paper cut is specified.
(5) FEED switch
Feeds the paper. It is fed continuously while the switch is held down.
(6) Paper holder
Set the paper roll in this holder.
(7) PNE sensor
Detects that the paper is running out.
(8) DIP switch
Initially sets the printer at power-on and sets the functions.
(9) Platen roller unit
Detach this unit when the paper is jamming or when you clean the head.
(10) Head-up lever
Used when replacing the paper or detaching/reattaching the platen roller unit.
(11) Paper cutter
Cuts the printed paper.
(12) Power connector
Connects to the accessory AC adapter (27AD).
(13) Interface connector
Connects to a communication interface cable. There are two types, for serial
and parallel interfaces.
(14) Printer cover
Detach this cover when replacing the paper.
— 9 —
Advertisement
Table of Contents
