Trouble Shooter And Service - AEG L 76460 TL User Manual

EMERGENCY DRAIN
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (3) of
'To clean the drain filter'.
If necessary, clean the filter.
Put the drainage duct back and close
the drain filter flap.
FROST PRECAUTIONS
If the appliance is installed in an area
where the temperature can be less than
0 °C, remove the remaining water from
the inlet hose and the drain pump.
1. Close the water tap and disconnect
the inlet hose.

TROUBLE SHOOTER AND SERVICE

The start of the appliance does not oc-
cur or it stops during operation.
4. Remove the inlet hose behind the
appliance.
5. Clean the filter in the valve with a
stiff brush or a towel.
6. Install again the inlet hose. Make
sure that the couplings are tight to
prevent leakages.
7. Open the water tap.
90˚
2. Put the end of the inlet hose in a
container and let the water flow out
of the hose.
3. Do the Drain programme and let it
operate until the end of the cycle.
4. Turn the programme knob to Stop
to disconnect the appliance from
the power supply.
5. Disconnect the appliance.
WARNING!
Make sure that the temperature
is more than 0 °C before you
use the appliance again.
The manufacturer is not respon-
sible for damages caused by
low temperatures.
First try to find a solution to the prob-
lem (refer to the table). If not, contact
the service centre.
ENGLISH 19