AEG L 76485 FL User Manual

AEG L 76485 FL User Manual

Hide thumbs Also See for L 76485 FL:

Advertisement

EN User manual
L 76285 FL
L 76485 FL

Advertisement

Table of Contents
loading

Summary of Contents for AEG L 76485 FL

  • Page 1 EN User manual L 76285 FL L 76485 FL...
  • Page 2: Table Of Contents

    13. INSTALLATION ............27 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler –...
  • Page 3: Safety Information

    ENGLISH 1. SAFETY INFORMATION Before the installation and use of the appliance, careful- ly read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use cau- ses injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
  • Page 4: Safety Instructions

    • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali- fied persons in order to avoid a hazard. • The operating water pressure (minimum and maxi- mum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) •...
  • Page 5: Technical Information

    ENGLISH mains plug, use a 13 amp ASTA (BS • Do not touch the glass of the door 1362) fuse. while a programme operates. The glass can be hot. • • Make sure that you remove all metal objects from the laundry. This appliance complies with the •...
  • Page 6: Product Description

    Level of protection against ingress of solid particles IPX4 and moisture ensured by the protective cover, ex- cept where the low voltage equipment has no pro- tection against moisture Minimum 0,5 bar (0,05 MPa) Water supply pressure Maximum 8 bar (0,8 MPa)
  • Page 7: Control Panel

    ENGLISH 4.1 Accessories Spanner To remove the transit bolts. Plastic caps To close the holes on the rear side of the cabinet after the removal of the transit bolts. Anti-flood inlet hose To prevent possible leakage Plastic hose guide To connect the drain hose on the edge of a sink.
  • Page 8 – Set again the washing programme 5.1 On Off button and all possible options. Press this button to activate or deacti- • After 5 minutes from the end of the vate the appliance. A tune sounds when washing programme. Refer to 'At the the appliance is activated.
  • Page 9 ENGLISH • The programme time When the programme starts, the time decreases with steps of 1 mi- nute. • The delay start When you press the delay start button, the display shows the delay start time. • Alarm codes If the appliance has a malfunction, the display shows alarm codes. Re- fer to 'Troubleshooting' chapter.
  • Page 10: Programmes

    10 www.aeg.com • To activate the function, press button Spin phase is off. and button at the same time until the display shows the symbol 'Rinse Hold' function is • To deactivate the function, press but- and button at the same time until the symbol goes off.
  • Page 11 ENGLISH Programme Type of load Cycle description Functions Temperature max. weight of load Cottons + Pre- White and coloured Prewash SPIN REDUC- wash cotton with heavy Wash TION 95° - Cold soil. Rinses RINSE HOLD max. 8 kg Long spin STAIN EXTRA RINSE TIME SAVE...
  • Page 12 12 www.aeg.com Programme Type of load Cycle description Functions Temperature max. weight of load Rinse Hand washing Rinses SPIN REDUC- items. Long spin TION RINSE HOLD EXTRA RINSE Jeans All items in jeans. Wash SPIN REDUC- 60° - Cold Jersey made items...
  • Page 13 ENGLISH STEAM PROGRAMMES Type of load Max. load Programme Cotton and synthetic items. up to 1.5 Kg Steam Refresh This cycle removes odours from the laundry. Steam does not re- move animal odours. Cotton and synthetic items. up to 1.5 Kg Steam Anticrease This programme helps to dew- rinkle the laundry...
  • Page 14: Consumption Values

    14 www.aeg.com 7. CONSUMPTION VALUES At programme start the display shows the duration programme for the max- imum load capacity. During the washing phase the programme duration is automatically calcula- ted and can greatly be reduced if the laundry load is lower than the maxi- mum load capacity (e.g.
  • Page 15: Before First Use

    ENGLISH 8. BEFORE FIRST USE To activate the drain system, put 2 li- detergent dispenser. Set and start a tre of water in the main wash com- programme for cotton at the highest partment of the detergent dispens- temperature without laundry. This removes all possible dirt from the drum and the tub.
  • Page 16 16 www.aeg.com The detergent compartment for the prewash phase and the soak programme. Add the detergent for prewash and soak before the start of the programme. The detergent compartment for the washing phase. If you use a liquid detergent, put it immediately before you start the programme.
  • Page 17 ENGLISH To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid deter- gent than the limit showed in the flap. –...
  • Page 18 18 www.aeg.com • The acoustic signals operate. Press button , the appliance starts the countdown of the delay • In the display comes on. start. • The indicator of the Start/Pause but- When the countdown is completed, goes off. the programme starts automatically.
  • Page 19: Hints And Tips

    ENGLISH 10. HINTS AND TIPS 10.1 The laundry load 10.3 Detergents and additives • Divide the laundry in: white, coloured, • Only use detergents and additives synthetics, delicates and wool. specially made for washing machines. • Obey the washing instructions that are •...
  • Page 20: Care And Cleaning

    20 www.aeg.com Water hardness table Water hardness Level Type °dH °T.H. mmol/l Clarke soft 0-15 0-1.5 medium 8-14 16-25 1.6-2.5 10-16 hard 15-21 26-37 2.6-3.7 17-25 very hard > 21 > 37 >3.7 >25 11. CARE AND CLEANING WARNING! CAUTION! Do not use alcohol, solvents or chemical products.
  • Page 21 ENGLISH 11.6 Detergent dispenser To clean the dispenser: Press the lever. Pull the dispenser out. Remove the top part of the liquid additive compartment. Clean all the parts with water. Clean the dispenser recess with a brush. Put back the dispenser in the recess. •...
  • Page 22 22 www.aeg.com To clean the drain pump: Open the drain pump door. Pull the flap out to remove it. Put a container below the recess of the drain pump to collect the water that flows out. Press the two levers and pull for- ward the drainage duct to let the water flow out.
  • Page 23 ENGLISH Clean the filter under the water tap and put it back in the pump into the special guides. Make sure that you tighten correctly the filter to prevent leakages. Put the flap back and close the drain pump door. 11.8 The inlet hose filter and •...
  • Page 24: Troubleshooting

    24 www.aeg.com Put the drainage duct back and close the Close the water tap. drain pump flap. Remove the water inlet hose When you drain the water with the emer- Put the two ends of the inlet hose in gency drain procedure, you must acti-...
  • Page 25 ENGLISH Problem Possible cause Possible solution The appliance The water drain hose is Make sure that the water drain does not drain the damaged. hose has no damages. water. The filter of the drain Clean the filter of the drain pump is blocked.
  • Page 26 26 www.aeg.com Problem Possible cause Possible solution Leakages from the drain Make sure that the drain pump pump. filter is tight. The water drain hose is Make sure that the water inlet damaged. hose has no damages. You cannot open...
  • Page 27: Installation

    ENGLISH 13. INSTALLATION 13.1 Fixing plate kit If you install the appliance on a plinth, secure the appliance in the fixing plates. (4055171146) Follow the instructions supplied with the kit. Available from your authorized dealer. 13.2 Unpacking Use the gloves. Remove the external film.
  • Page 28 28 www.aeg.com Open the door. Remove the poly- styrene piece from the door seal and all the items from the drum. Put one of the polystyrene packag- ing elements on the floor behind the appliance. Carefully put down the appliance with the rear side on it.
  • Page 29 ENGLISH Remove the three bolts. Use the key supplied with the appliance. Pull out the plastic spacers. Put the plastic caps in the holes. You can find these caps in the user manual bag. WARNING! We recommend that you keep Remove all the packaging and the packaging and the transit the transit bolts before you install...
  • Page 30 30 www.aeg.com • The appliance must be level and sta- ble. CAUTION! Installation on suspended Do not put cardboard, wood or flooring equivalent materials below the appliance feet to adjust the level. Suspended wooden floors are particular- ly susceptible to vibration. To help pre-...
  • Page 31 ENGLISH • Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Con- tact the service centre for the re- placement of the inlet hose.
  • Page 32 32 www.aeg.com • On the edge of a sink. • Make sure that the plastic guide can- not move when the appliance drains. Attach the guide to the water tap or the wall. • To a stand pipe with vent-hole.
  • Page 33 ENGLISH • Directly to a built-in drain pipe in the room wall and tighten it with a clip. You can extend the drain hose to maximum 400 cm. Contact the service centre for the other drain hose and the extension. 14.
  • Page 34 34 www.aeg.com...
  • Page 35 ENGLISH...
  • Page 36 www.aeg.com/shop...

This manual is also suitable for:

L 76285 fl

Table of Contents