Maintenance - Raider RD-AW03 User Manual

10 www.raider.bg
Excess oil should be avoided.
In case you need to store the machine for an extended period of time (overnight, weekends, etc.), it should
be thoroughly crushed. The machine must be turned on for about 30 seconds to ensure that the oil is evenly
distributed in The whole instrument. This tool should be stored in clean, dry environment.
It is very important that the machine is properly oiled, retains pipe lubricator complete and properly regulated.
If not lubricated properly it will not work properly and parts will wear prematurely.
Use a suitable lubricant in the lubricator. The lubricant must be low air flow or changing the type of airflow and
should be filled to the proper level. Use only recommended lubricants specifically designed for pneumatic
applications. Alternates may harm the rubber compounds in the machine, O-rings and other rubber parts.
IMPORTANT!
If not installed Combined Regulator, Air Filter, Water Trap & Lubricator group air system, pneumatic tools
should be lubricated at least once a day or after 2 hours with 2-6 drops of oil, depending on the work
environment directly through the hole in the hull.
Inclusion and exploitation
WARNING: Make sure you read, understand and apply safety instructions before use.
R- anticlockwise
4. Ensure supply air is clean and does not exceed 0.62MPa during operation of the machine. Too high air
pressure and dirty air will shorten the life of the machine and excessive wear can be dangerous causing
damage or personal injury.
5. Keep children away from the machine and jobs using tools.
DO NOT use the extra power on the machine.
Do not let the machine idle prodalzhenitelno time as this will shorten its life.
Installing / replacing insert
Attention !!! Before inserting or replacing the faceplate Always turn off air supply!
a. Place the insert tip of the square, pressing to overcome the grip of the stack of spring
b. For removal of the insert must be pulling.

Maintenance

WARNING: Disconnect wrench from air supply before changing accessories, servicing or performing
maintenance. Replace or repair damaged parts. Use genuine parts only. Non-authorised parts may be
dangerous and will invalidate the warranty.
1. Lubricate the air impact wrench daily with a few drops of air tool oil dripped into the air inlet
2. Clean the tool after use. DO NOT use worn, or damaged tool.
3. Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose
connectors. To remedy check the air supply .
b) Grit or gum deposits in the tool may also reduce performance. If your model has an air strainer (located
1. Remove the plastic plug the hole for air supply. Screw the
nozzle attachment to the air supply hose. Connect the machine
to the air hose.
IMPORTANT: When connecting to a hose for air supply not
press the lever to drive !!!
2. Press the shutter button for the machine. While the button is
pressed, the machine will work.
3. Adjust the direction of rotation becomes a lever -
F - in a clockwise direction