Table of Contents
Advertisement
GENERAL POWER TOOL SAFETY WARNINGS.
WARNING
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result
in electric shock, fire and/or serious injury. Save all warnings and Instructions for future reference.
Used symbols on marking plate of the machine:
Information about the battery and the charger.
The rechargeable circular saw is supplied without a battery and charger. Use only battery and charger
from the R20 System series
CIRCULAR SAW SAFETY WARNINGS.
Usage. This machine is suitable for cutting wood, other similar materials and plastic.
BLADE CHANGING PROCEDURE:
Slowly rotate the disc with the key until the lock is triggered. Unscrew the disc fixing screw by turning
left. Pull the fuse with the lever and remove the disc. The contact areas between the inner flange,
disc, outer flange and fixing screw must be dust-free. Insert a new disc, making sure the direction
of rotation is correct. The direction of rotation is indicated by the arrow on the disc and on the fuse.
Tighten the fixing screw.
Do not use abrasive discs. Use only sharp, undamaged discs. Do not use cracked or discolored discs.
Do not use discs made of highly alloyed high-speed steel. Do not use discs that do not meet these
guidelines. The disc must be suitable for idle speed. Use a cutting disc suitable for the workpiece.
BEFORE USE
Attention! Check whether the protective cover is moving normally, without interfering in some
sort of way blade.
Attention! Place the blade by selecting disk rendered technical parameters.
1. Check the blade meets the following requirements: its speed is equal to or greater than that of
the circular.
Attention! Never use cracked or damaged saw blade.
2. Before placing the blade make sure saw is disconnected from the power cord. And the key is in
position "OFF".
FIXING DETAIL
To prevent "kick" of the circular do not put the detail in the following way:
Place the workpiece as proved in the figure below
13
Advertisement
Table of Contents
