Cisco SFE2000 Release Note page 6

RELEASE NOTES
Linksys One Ready Communications Solution
Headline Description
When administratively setting all ports in a stack of two units to
"Up" using the window screen.
Stacking
Bridging -> Port Management-> Port Settings -> Edit,
unit 2 reboots.
When the default settings are restored using the web interface or
Stacking - Restore to
the Menu CLI interface, the configuration file reverts to default
Default
settings, but stacking settings are not restored.
Stacking- Restore to
When the default settings are restored using hard restore defaults,
all default settings are reset, including stacking configuration.
Default
Stacking- Restore to
When the hardware "reset to default" button is pushed on the
master unit, all default settings are restored on the master unit.
Default
If the configuration file, which has information for all units in the
stack, is first reset to default (and synchronized with the backup
unit), then, the master unit settings are reset to default (stackable
Stacking- Restore to
mode, auto-numbering). Note that as a result of the reset, the
master unit is reset. During the reset, the backup unit becomes
Default
master of the stack, with the default configuration file. The
master unit then rejoins the stack, and is assigned a new number,
using auto-numbering.
The stacking configuration is reset for each unit individually.
Performing a hard reset on any unit resets it to its default state of
a stackable unit in auto-numbering mode. Performing a hard reset
Stacking- Restore to
on any slave unit (including the backup unit) results in setting the
unit to be in stackable mode with auto-numbering mode enabled.
Default
If the stack is in ring configuration, it will become a chain until
the unit "rejoins" the stack. The unit is re-assigned a number,
based on the auto-numbering algorithm.
Headline Description
Security Suite - DoS User cannot set an IP address for which Martian Address
Prevention - Martian protection will be defined, in addition to preconfigured IP
Address addresses.
Security Suite - DoS
The address 127.0.0.0/8, which is used as the internet host
Prevention - Martian
loopback address, is not predefined in the Martian Address list.
Address
Supported Firmware Functionality
6
Stacking
Security
Linksys One Ready Communications Solution SFE2000/SFE2000P and SGE2000/
1 February 2007
Reference
67902
Reference
68696
68697
SGE2000P