Removing The Mower - Toro 78477 Operator's Manual

8. Release the latch levers and push carrier frame
down. Latch pins should lock.
9. Select hole in mower hanger bracket
corresponding to the height-of-cut desired. Lift
on side and front handles to align holes and
insert clevis pin (Fig. 8).
10. Secure clevis pin with hairpin cotter (Fig. 8).
Note: All four clevis pins should be in the
same hole location for a level cut.
3
1
Figure 8
1. Mower Hanger Bracket
2. Clevis Pin
11. Secure PTO cover down with 5/16–18 x 7/8"
(11 mm) shoulder bolt and 5/16" flange nut
(Fig. 9).
Figure 9
1. PTO cover
2. Shoulder bolt
5/16–18 x 7/8" (11 mm)
2
3. Hairpin Cotter
3
1
2
3. Flange nut 5/16"

Removing the Mower

1. Remove 5/16–18 x 7/8" (11 mm) shoulder bolt
and 5/16" flange nut holding PTO cover down
(Fig. 9).
2. Drive roll pin through hole in universal joint to
remove PTO drive shaft from gearbox shaft
(Fig. 7).
Note: Roll pin and drive shaft remain with
traction unit.
4
3
Figure 10
1. PTO Driveshaft
2. Universal Joint
Installation
1
2
3. Gearbox shaft
4. Roll Pin
7