Table of Contents
Advertisement
Installation
3.
Tilt mower into raised position, refer to: Tilting
the Mower.
4.
Remove 3/8" x 7/8" (23 mm) shoulder bolt and
3/8" locknut securing spring end plate assembly
to carrier frame (Fig. 11).
Figure 11
1. Spring Assembly
2. Shoulder Bolt 3/8" x 7/8"
(22 mm)
5.
Carefully lower mower from vertical position
using front lift handles, refer to: Tilting the
Mower.
6.
Remove hairpin cotters and clevis pins from
mower hanger brackets and remove mower from
carrier frame (Fig. 12).
3
1
Figure 12
1. Mower Hanger Bracket
2. Clevis Pin
8
3
2
1
3. Locknut 3/8"
2
3. Hairpin Cotter
7.
Raise the carrier frame and roll the mower away
from traction unit.
8.
Lower carrier frame and remove hairpin cotters
and pivot pin assemblies securing push arms to
traction unit clevises (Fig. 13).
Note:
Save all hardware for use when
installing mower. Items 3 and 4 are
part of traction unit.
4
2
Figure 13
1. Clevis
2. Push Arm
1
3
3. Pivot Pin Assembly–flat
4. Hairpin Cotter
Advertisement
Table of Contents
