Daikin JEHBSCU0200M1 Technical Manual page 32

9.15 Wiring
The unit must be isolated from power supply prior to installation. In order to ensure the safety of the installation
and its smooth operation, it is necessary to:
•
Verify the installation is compatible with the wiring diagram.
•
Select the motor circuit breaker by using the maximum continuous current. Refer Section 4.
•
Size the wiring for the connection (power and control circuit) according to the properties of the installed
unit.
•
Protect and earth the electrical power supply.
•
Carry out electrical connections according to the norms of the respective country.
•
Secure the cable from touching hot parts and sharp edges with cable clamps.
•
Close the electrical box after completion of the wiring.
9.16 Commissioning of the Condensing Unit
Make sure all isolation valves are fully open before starting the system for the first time. The shut off valve on the
condensing unit could found on outlet of liquid receiver, inlet and outlet of condensing unit.
T-CU01-MAR21-3 32