Battery Charging; Changing The Battery; Emergency Stop - Handicare SystemRoMedic EvaDrive Instructions For Use Manual

Battery charging

Always charge the lift after use to ensure that the battery is fully charged.
Charging procedure:
• Connect the charger cable to the batterypack, plug in
the wall socket and switch on at plug socket.
• Check to ensure that the light on the charger lights up and that
the battery's power switch is switched on!
• Charging stops automatically when battery is fully charged.
NOTE! The lift must be charged for at least 10 hours before it is used for the first time. For maximum service life,
charge batteries regularly. We recommend daily charging when the lift is used daily.
Only the dedicated charger may be used.

Changing the battery

Loosen the two screws that holds the handlebar using an Allen key, and move
up wards as far as possible. Remove the battery cable. Slide the battery off
the rails on the on the backplate mounted on the mast.
Slide the new battery into the rails. reattach the handlebar and the battery cable.
Handle the battery with care. Do not drop.

Emergency stop

Emergency stop: Press the emergency-stop button on the EvaDrive cover. Emergency stop switches off all of the lift's
electrical functions. The battery scale continues to light continuously.
Resetting: Turn the emergency-stop button in the direction of the arrows until the button pops out.
Compatibility
EvaDrive is adapted for Eva450EE (60900002) and Eva600EE (60900003).
SystemRoMedic
I N S T R U C T I O N S F O R U S E
TM
1. The green LED light confirms that the charger
is connected to the power outlet and is receiving
power.
2. Red light indicates charging.
3. Green light indicates full charge.
13