Advertisement
Available languages
Available languages
26. This appliance is intended to be used in household and similar applications such as:
EN
– Staff kitchen areas in shops, offices and other working environments;
– Farm houses;
TH
– By clients in hotels, motels and other residential type environments;
– Bed and breakfast type environments.
VN
27. Avoid spillage on the connector.
AR
28. Be careful potential injury from misuse.
29. The heating element surface is subject to residual heat after use.
30. Save these instructions.
BEFORE FIRST USE
If you are using the kettle for the first time, it is recommended that you should clean your kettle before use
by boiling the Max capacity of water once and then discarding the water twice. Wipe the surface with a
damp cloth.
NOTE: The max capacity of kettle is 1.7L.
USING YOUR ELECTRIC KETTLE
1. Place the kettle on the flat surface.
2. To fill the kettle, remove it from the power base and open the lid by pressing down lid release button,
then fill the kettle with the desired amount of water and close the lid. The water level must be within the
Min and the Max level. Too little water will cause the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the switch and the indicator will light up, and then
the kettle starts to boil the water. The kettle will switch off automatically once the water has boiled. If
necessary, it will take you 30 seconds to wait before pressing the switch again to re-boil the water. You
may shut off the power by lifting switch up or directly lift the kettle from the power base at any moment
to stop boiling process.
NOTE: Ensure that switch is free of obstructions and the lid is firmly closed, the kettle will not turn off if
the switch is being constrained or if the lid is not closed.
5. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water may result in scald,
besides, don't open the lid while the water in the kettle is hot.
6. The kettle will not re-boil until the switch is pressed again. The kettle may be stored on the power base
when not in use.
NOTE: Always disconnect the power supply when not use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water, the function of boil-dry protection will
automatically switch off the power. If this occurs, allow the kettle to cool prior to filling with cold water
before re-boiling.
4
www.electrolux.com
Advertisement
