Eastwood 31662 Instructions Manual page 5

SET-UP
• Using a good quality Teflon sealing tape (not included), thread the 1/4" MNPT, Male quick
disconnect inlet fitting into the air inlet.
CONNECTION
• Be sure that the air supply to the tool is clean and dry. Moisture in the supply line will quickly
damage the motor and valves.
• A minimum 3/8" I.D. air line should be used for optimal performance.
OPERATION
• Open the Chuck Jaws by
rotating the Chuck Shell in a
Counter-Clockwise direction
(as viewed from the open end)
while gripping the Chuck Base
(FIG 1).
• Insert drill bit or accessory
shank into Chuck Jaws.
• Close the Chuck Jaws by
rotating the Chuck Shell in
a Clockwise direction (as
viewed from the open end)
while gripping the Chuck Base
(FIG 1).
• For forward direction, discon-
nect from air supply Slide the
Direction Control right to the
"F" direction (FIG 2).
• Connect air supply, depress
Trigger to begin rotating
action. Speed is regulated
by pressure applied to the
Trigger.
• To reverse drill, disconnect
from air supply, Slide the Direction Control left to the "R" direction (FIG 2).
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 1
Chuck Base
FIG. 2
Chuck
Close
Rotate
Open
5