Required Tools And Materials; Decommissioning And Disposal - Siemens RUGGEDCOM RMC20 Installation Manual

8
Figure 1.1
POWER LED
TX/RX LEDs
Serial Terminal
Power Supply Terminal
MODE Switch
Communication Ports
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RMC20:
AC or DC power cord (16 AWG)
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #8-32 screws
1.4

Decommissioning and Disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
RUGGEDCOM RMC20
Installation Manual, 04/2021, C79000-G8976-1007-10
Chassis Ground Terminal
RUGGEDCOM RMC20
Tools/Materials
Illuminates when power is being supplied to the device.
State
Green
Off
Indicate the connection status of the serial terminal.
LED State
TX Yellow
(Blinking)
RX Yellow
(Blinking)
The RS232/RS422/RS485 serial terminal serves a dual purpose:
• The RS232 terminals allow for a direct interface with the device
and access to initial management functions.
• The RS422/RS485 terminals allow for half or full duplex serial
connections respectively. For more information, refer to
"Communication Ports (Page
A pluggable terminal. For more information, refer to:
• "Connecting Power (Page 14)"
• "Power Supply Specifications (Page 23)"
Sets the operating mode for the device. For more information, refer
to "Setting the Operating Mode (Page
Receive and transmit data. For more information about the
various ports available for the RUGGEDCOM RMC20, refer to
"Communication Ports (Page
For connecting power to the device.
For connecting the device to the network.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Introduction
1.3 Required Tools and Materials
Description
Power is on
Power is off
Description
Transmitting serial data
Receiving serial data
17)".
9)".
17)".
Purpose
3