Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Pentair AQUATIC ECO-SYSTEMS ARIAS 6000
Summary of Contents for Pentair AQUATIC ECO-SYSTEMS ARIAS 6000
- Page 1 AQUATIC ECO-SYSTEMS ™ ARIAS 6000 FIBERGLASS AQUACULTURE ™ SAND FILTER WITH MULTIPORT VALVE MODELS: A6000-40, A6000-60, A6000-100 INSTALLATION AND USER’S GUIDE IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS...
-
Page 2: Table Of Contents
CUSTOMER SERVICE / TECHNICAL SUPPORT If you have questions about ordering Pentair Aquatic Eco-Systems, Inc., replacement parts and products, please contact: Customer Service Web site 8 AM to 7 PM — Eastern and Pacific Times Visit www.pentairaes.com Phone: (877) 347-4788... -
Page 3: Important Warning And Safety Instructions
Pressurized This guide provides installation and operation instructions for air can cause the lid to separate which can result in this product. Consult Pentair with any questions regarding this severe injury, death, or property damage. equipment. - Page 4 IMPORTANT WARNING AND SAFETY INSTRUCTIONS The following information should be read carefully This filter is intended for use in aquaculture since it outlines the proper manner of care and installations ONLY. DO NOT use with any type of swimming pool, hot tub, or spa. operation for your filter system.
-
Page 5: Section 1: Installation
Section 1 Installation Note: Before installing this product, read and follow all warning notices and instructions in this manual. Installing the Arias™ 6000 Sand Filter Only a qualified service person should install the sand filter. This filter is designed and intended to filter water. Introduction The following general information describes how to install the sand filter. - Page 6 Arias™ 6000 Sand Filter Installaton Filters should never be tested or subjected to air or gas under pressure. All gases are compressible and under pressure create a danger. Severe bodily injury or property damage could occur if the filter is subjected to air or gas pressure. 1.
-
Page 7: Initial Start-Up
15. A positive shut-off valve is not recommended at the outlet of the filtering system. If the system is ever run with such a valve closed, the internal air relief system becomes inoperative which can cause the filter to separate. Additionally, running the system with no flow will seriously damage the equipment. -
Page 8: Section 2: Maintenance
Section 2 Maintenance This section describes how to maintain the Arias™ 6000 Sand Filter. Filter Care The filter is a very important part of the system and installation. Follow these suggestions for long trouble-free operation: 1. To clean the exterior of the filter of dust and dirt, wash with a mild detergent and water then hose off. Do not use solvents. -
Page 9: Arias ™ 6000 Filter Backwash Procedure
Filter Backwash Procedure To prevent equipment damage and possible injury, always turn off pump before changing valve positions. 1. Stop the pump. 2. Be sure the suction and backwash lines are open so that water is free to come from the system and flow out the backwash line. -
Page 10: Winterizing Your Arias 6000 Filter
Winterizing your Filter 1. In areas that have freezing winter temperatures, protect the pool equipment by backwashing the filter. 2. After backwashing, shut the pump off, open the manual air bleeder on the 6-Way Valve (except A6000-100), and move the handle of the Multiport Valve to the Winterize Position. 3. - Page 11 Filter Problems and Corrective Actions PROBLEM CAUSE REMEDY Water not sufficiently clean 1. Water chemistry not adequate to inhibit Maintain water chemistry or consult service algae growth. technician. 2. Too frequent a backwash cycle. Allow pressure to build to 10 psi above clean filter condition before backwashing.
-
Page 12: Section 4: Replacement Parts
Section 4 Replacement Parts A6000-40 A6000-60 ARIAS™ 6000 SAND FILTER A6000-100 NOTE 1: Item 3 O-ring - Standpipe is used on model A6000- 100 Filters only. NOTE 2: Replacement of Tank ft. requires the use of mounting tape. See part number listed. NOTE 3: Lubricate O-ring liberally with silicone lubricant and tighten to following specifications: A6000-40, A6000- 60, hand tighten plus 1/4”... - Page 13 ARIAS™ 6000 Sand Filter Replacement Parts Item No. Part Number Descrip on 272544 (A) VALVE 1½ in. 6-WAY CLAMP STYLE 271579 (B) VALVE 2 in. 6-WAY CLAMP STYLE 281187 (C) VALVE 2 in. 6-WAY CLAMP STYLE 272541 (A) O-RING VALVE BODY 3/16 in. X 4¾ in. I.D. 275333 (B) O-RING VALVE BODY 3/16 in.
- Page 14 Notes Arias™ 6000 Fiberglass Aquaculture Sand Filter with Multiport Valve Installation and User’s Guide...
- Page 15 Notes Arias™ 6000 Fiberglass Aquaculture Sand Filter with Multiport Valve Installation and User’s Guide...
-
Page 16: P/N 151036 Rev. A 4/13
WWW.PENTAIRAES.COM All Pentair trademarks and logos are owned by Pentair Inc. Pentair Aquatic Eco-Systems is a trademark and/or registered trademarks of Pentair Water Pool and Spa, Inc. and/or its affiliated companies in the United States and/ or other countries. Unless expressly noted, names and brands of third parties that may be used in this document are not used to indicate an affiliation or endorsement between the owners of these names and brands and Pentair Aquatic Eco-Systems.
Need help?
Do you have a question about the AQUATIC ECO-SYSTEMS ARIAS 6000 and is the answer not in the manual?
Questions and answers