Table of Contents
Advertisement
2)
Remove the material covering the QuicKART and components. Take care
not to bend the antenna when removing the covering. Cut the banding
material, which holds the QuicKART to the pallet.
3)
Raise the hood to find a small box containing the remote control, and cart
coupler hardware. Remove this box and set it aside.
4)
On the M3 E only, remove the tower pin and clip. Unclip the red cable holding
the hood open and raise the strobe tower. Carefully reinstall the pin and clip
into the tower tube and clip the cable back in place.
Step 3
5)
To attach the cart coupler yokes/cups, select a typical cart from the store and
then refer to the diagrams starting on page 30.
6)
To remove the QuicKART from the pallet, use a sturdy wooden board(s) to
create a ramp. Insert the key and turn it counter-clockwise to place the
QuicKART in "manual mode". Use the nudge switch on the M3 E strobe
tower to guide the QuicKART forward, down the ramp to the floor. .
7)
Turn "OFF" the QuicKART
8)
Each hand-held remote control transmitter operates on a unique pre-
programmed code. For the QuicKART to operate in the Radio Mode, the
receiver must be programmed to match the hand held transmitter. See page
35 for directions on how to program the remote control transmitter.
Dane Technologies, Inc.
7105 Northland Terrace, Minneapolis, MN 55428 / 888-544-7779 / 763-544-7779 / Fax 763-544-4234
www.danetechnologies.com
Step 4
Step 5
QuicKART
Remove pin and clip.
Reinstall into tube.
Owners Manual
970-047
B 2-9-09
REV
7
Hide quick links:
Advertisement
Table of Contents
