Programming The Remote Control - Dane Technologies QUICKART M3 Owner's Manual

PROGRAMMING THE REMOTE CONTROL

Each hand-held remote control transmitter operates on a unique pre-
programmed code. For the QuicKART to operate in the Radio Mode, the
receiver must be programmed to match the hand held remote control. Every
time the batteries in the remote control are replaced, the remote control may
need to be reprogrammed to match the receiver. If the QuicKART stops
responding to the remote control there may be something wrong with the
transmitter. Check the status of the remote battery by depressing one of the
remote buttons. If the green LED light on the transmitter does not illuminate,
change the battery and reprogram the remote control as follows:
5-button remote:
1. Turn the QuicKART to "RADIO". Hold remote about arms length from the antenna.
2. Press and continue to hold the Stop button on the hand-held remote (page 12)
3. Press the Horn button on the hand-held remote three times. (page 12) The LED on
the remote changes color from green to red and flashes fast.
4. Press the Rubber button located on the underside (M3-M3 HD) of the CONTROL
PANEL (see page 13)
6-button remote:
1. Turn the QuicKART to "RADIO". Hold remote about arms length from the antenna.
2. Press and continue to hold the Stop button on the hand-held remote (page 19)
3. Press the Slow Reverse button on the hand-held remote three times. (page 19)
The LED on the remote changes color from green to red and flashes fast.
4. Press the Rubber button located on the left side (M3 E) of the CONTROL PANEL
(see page 20)
The horn should sound twice indicating the reprogram is complete. Release the Stop
button and the QuicKART is ready for operation. The remote LED should turn back to
green color.
If the horn did not sound, retry the above steps making sure that the switch on
the control panel is on "RADIO". If the horn still did not sound, you can also
determine if the reprogram was successful by pressing the slow forward button
on the remote to see if the QuicKART now responds to the remote signal.
Dane Technologies, Inc.
7105 Northland Terrace, Minneapolis, MN 55428 / 888-544-7779 / 763-544-7779 / Fax 763-544-4234
www.danetechnologies.com
QuicKART Owners Manual
970-047 B 2-9-09
REV
35