Toto NEOREST SE Installation Manual page 3

After the installation, test the ground fault circuit interrupter (GFCI) protecting this
appliance and periodically check it in accordance with the manufacturer's instruc-
tions.
● An improperly functioning GFCI could lead to electric shock or fire.
Be sure that the equipment is installed in a stable place with sufficient load-bearing
strength, as set forth in the Installation Guide.
● Improper installation could cause the equipment to fall or topple over, causing injury.
When installing the function module using a metal lath or wire lath support, be certain
not to connect the function module and support electrically.
● Doing so could lead to electric shock, overheating or fire.
!
When connecting the wiring, be certain that the power supply is not turned ON.
Required
● Doing so could lead to electric shock.
The electronic components must be installed out of the reach of users in the bath-
room. (However, this rule is not applied to ultralow voltage supply components at 12
V or less, such as remote controllers.)

Otherwise, an electric shock could result.

The function modules must not be installed in the bathroom.
The electronic components must be fixed so that they will not fall into the bathtub.

Otherwise, an electric shock could result.

The function modules must not be installed in the bathroom.
Ensure that you have an ergonomic working position during transport and assembly.
● Take care at every stage that your move is safe. Ensure that you have assistance to avoid
risk of accident or injury.
Observe the current local prevention of accidents and building regulations as well as
sanitary and environmental protection rules during installation.
Do not place anything heavy on the tub or anything in the tub for standing on.
● Doing so could cause damage.
Do not drop any heavy or hard objects in the bathtub.
● Injury may result from cracks in the bathtub or leaking water may contaminate or ruin
household property.
Prohibited
Keep sources of heat at a distance.
Do not smoke.
● Otherwise there is a risk of damage.
Do not install the bathtub outdoors or in a location where it will be constantly exposed
to sunlight (for example, in a sunroom).
● Otherwise there is a risk of frost damage or discoloration.
Do not bend the hoses or cables.
When transporting the bathtub, do not carry by the hoses or plumbing or strike it with
anything hard.
3
WARNING
!
CAUTION
!