Hc Warning; Things To Be Done For Energy Saving; Recommendations For The Fresh Food Compartment; Installation - Beko RDNT371 Series User Manual

HC warning

If your product's cooling system contains R600
This gas is ammable. Therefore, pay attention to
not damaging the cooling system and piping during
usage and transportation. In the event of damage,
keep your product away from potential re sources
that can cause the product catch a re and ventilate
the room in which the unit is placed.
Ignore this warning if your product's
cooling system contains R134a.
Type of gas used in the product is stated in the type
label which is on the left wall inside the refrigerator.
Never throw the product in re fordisposal.

Recommendations for the fresh food compartment

*optional
Do not allow the food to touch the temperature
sensor in fresh foodcompartment. To allow the fresh food
compartment keep its ideal storage temperature
sensor must not be hindered by food.
Do not place hot foods in the product.
3

Installation

In case the information which are given in the user
manual are not taken into account, manufacturer will
not assume any liability for this.
Points to be paid attention to when the
relocation of therefrigerator
1. Your refrigerator should be unplugged.Before
transportation of your refrigerator, it should be
emptied and cleaned.
2. Before it is re-packaged,shelves, accessories, crisper, etc.
inside your refrigerator should be xed with adhesive
tape and secured against impacts. Package should
be bound with a thick tape or sound ropes and the
transportation rules on the package should be
strictly observed.
3. Original packaging and foammaterials should be
kept for future transportations or moving.Before
you start the refrigerator,
Check the following before you start to use
your refrigerator:
1. Clean the interior of therefrigerator as recommended in the
"Maintenance and cleaning" section.
2. Connect the plug of therefrigerator to the wall socket.When
the fridge door is opened, fridge internal lamp will turn on.
3. When the compressor starts tooperate, a sound will
be heard. The liquid and gases sealed with in the
refrigeration system may also give rise to noise, even
the compressor is not running and this is quite normal.
4. Front edges and both sides ofthe refrigerator may
feel warm. This is normal. These areas are designed
to be warm to avoid condensation.

Electrical connection

Connect your product to a grounded socket which is
being protected by a fuse with the appropriate capacity.

Things to be done for energy saving

Do not leave the doors of your refrigerator open for a long time.
Do not put hot food or drinks in your refrigerator.
Do not overload your refrigerator so that the air
circulation inside of it is not prevented.
Do not install your refrigerator under direct sunlight or near heat
emitting appliances such as ovens, dishwashers or radiators.
Keep your refrigerator at least 30cm away from heat
emitting sources and at least 5cm from electrical ovens.
Pay attention to keep your food in closed containers.
For products with a freezer compartment You can store
maximum amount of food items in the freezer
when you remove the shelf or drawer of the freezer.
Energy consumption value stated for yourrefrigerator
has been determined has been determined by removing
freezer shelf or drawer and under maximum load.
There is no harm to use a shelf or drawer according to
the shapes and size of food to be frozen.
Thawing frozen food in fridge compartment will both
provide energysaving and preserve the food quality.
Important:
The connection must be in compliance with national regulations.
The power plug must be easilyaccessible after installation.
Electrical safety of your refrigeratorshall be guaranteed only
if the earthsystem in your house complies with standards.
The voltage stated on the label located at left inner side
of your product should be equal to your network voltage.
Extension cables and multi plugs must not be used for
connection.
A damaged power cable must be replaced by a quali ed electrician.
Product must not be operated beforei t is repaired!
There is the risk of electric shock!

Disposing of the packaging

The packing materials may be dangerous for children.
Keep the packing materials out of the reach of children
or dispose of them by classifying them in accordance
with the waste instructions stated by your local
authorities. Do not throw away with regular house
waste, throw away on packaging pick up spots
designated by the local authorities The packing of
your refrigerator is produced from recyclable materials.

Disposing of your old refrigerator

Dispose of your old refrigerator without giving any
harm to the environment.
You may consult your authorizeddealer or waste collection
center of your municipality about the disposalof your refrigerator.
Before disposing of your refrigerator, cut out the electric
plug and, if there are any locks on the door, make them
inoperable in order to protect childrenagainst any danger.

Placing and Installation

If the entrance door of the room where the refrigerator
will be installed isnot wide enough for the refrigerator to
pass through, then call the authorized service to have
them remove the doors of your refrigerator and pass it
sideways through the door.
4 EN