5
Installing the Supports
Parts needed for this procedure:
2
Floor-plate support
16
Flange-head bolt (5/16 x 1-1/4 inches)
16
Flange nut (5/16 inch)
1
Left cab support
1
Right cab support
4
Hex-head bolt (3/8 x 1-1/4 inch)
4
Flange nut (3/8 inch)
4
Washer (3/8 inch)
Procedure
1.
Remove the 4 screws (1/4 x 1-1/4 inches) and 4
nuts (1/4 inch) from the floor plate
1. Nut (1/4 inch)
2. Screw (1/4 x 1-1/4 inches)
(Figure
Figure 2
3. Floor plate
2.
Use a floor jack under the frame to support the
front of the machine
1. Frame
3.
Remove 1 of the existing floor-plate supports
(Figure
Important:
2).
existing floor-plate supports simultaneously.
1. Existing floor-plate supports
g038333
7
(Figure
3).
Figure 3
4).
Do not remove both of the
Figure 4
g038334
g035246