7
Routing the Wire Harness
Parts needed for this procedure:
1
Fuse block
Hex-washer head screw (#10 x 3/4 inch)—for 2019
2
and after electric machines only
Serrated nut (#10)—for 2019 and after electric
2
machines only
Self-tapping screw—for 2019 and after gasoline
2
machines only
1
Fuse (15 A)
For Electric Machines
Important:
The Power Converter Kit is required
to use the cab on a Workman GTX Electric utility
vehicle. Contact your authorized Toro distributor
for more information.
1.
Install the new fuse block as follows:
•
For 2018 and before machines, snap the
new fuse block onto the existing fuse block
on the machine
Figure 17
1. To ground
2. To the fused wire
(Figure
17).
3. To the optional washer
pump kit
4. New fuse block
•
For 2019 and after machines, secure the
new fuse block using the 2 hex-washer head
screws (#10 x 3/4 inch) and 2 serrated nuts
(#10) as shown in
1. New fuse block
2. Hex-washer head screw
(#10 x 3/4 inch)
2.
For 2019 and after machines, connect the
female connector on the harness to the new
fuse block
3.
Connect the large connector on the new fuse
block to the optional power cable on the existing
fuse block
g035257
12
Figure
18.
Figure 18
3. Serrated nut (#10)
4. Female connector
(Figure
18).
(Figure
17).
g290937