Toro Cab Kit Operator's Manual page 11

11. Install the seat base.
Note:
You may need to position the 2 center
seat-belt anchors to allow the seat to drop into
place. Loosen the 2 locknuts (7/16 inch) on the
2 center seat-belt anchors, and tighten the 2
locknuts (7/16 inch) to 72 to 88 N∙m (53 to 65
ft-lb) after adjusting the position.
12. Remove the backing from the right, front and
left, front foam seals and attach the seals to the
machine (Figure
1. Left, front foam seal
13. Remove the backing from the foam seal and
attach the seal to the right side of the machine
(Figure 16).
Right Side Shown
1. Foam seal
15).
Figure 15
Figure 16
g035254
g037104
11