Technical Data; Before Starting The Equipment; Operation - Bavaria BCD 18/1 Li Original Operating Instructions

5. Technical data

Voltage supply
Idling speed
Torque settings
Forward and reverse rotation
Chuck capacity
Battery charging voltage
Battery charging current
Mains voltage for charger
Weight
Max. screw diameter
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Drilling in metal.
Vibration emission value a ≤ 2.5 m/s
h
K uncertainty = 1.5 m/s
2
Screwing without hammer action
Vibration emission value a ≤ 2.5 m/s
h
K uncertainty = 1.5 m/s
2
Additional information for power tools.
Warning!
The specified vibration value was established in
accordance with a standardised testing method. It may
change according to how the electric equipment is
used and may exceed the specified value in exceptional
circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
8
The specified vibration value can be used for initial
assessment of a harmful effect.
18 V d.c.
Keep the noise emissions and vibrations to a
0-350/0-1200 rpm
minimum.
19 + 1 •
yes
•
•
max. 10 mm
•
14.4–18V d.c.
•
•
1500 mA
Residual risks.
230–240 V ~ 50–60
Even if you use this power tool in accordance with
Hz
instructions, certain residual risks cannot be ruled out.
1.7 kg
The following hazards may arise in connection with the
equipment's construction and layout:
6 mm
1.
2.
3.
72 dB(A)

6. Before starting the equipment

3 dB
Be sure to read the following information before you
83 dB(A)
use your tool for the first time:
3 dB
1.
2.
3.

7. Operation

2
7.1 Charging the LI battery pack (Fig. 2/3)
The battery is protected from exhaustive discharge.
An integrated protective circuit automatically switches off
the equipment when the battery is flat. In this case the
2
chuck will cease to turn.
Warning! Do not press the ON/OFF switch any more
if the protective circuit has actuated. This may damage
the battery.
1.
2.
Only use appliances which are in perfect working
order.
Clean the tool regularly.
Adapt your working style to suit the tool.
Do not overload the tool.
Switch the tool off when it is not in use.
Wear protective safety equipment.
Lung damage if no suitable protective dust mask
is used.
Damage to hearing if no suitable ear protection is
used.
Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or is
not properly guided and maintained.
Charge the battery pack with the charger supplied.
An empty battery pack requires a charging period of
approximately 1 hour.
Only ever use sharp drill bits and screwdriver bits
which are suitable for the purpose and in faultless
condition.
Always check for concealed electric cables and gas
and water pipes when drilling and screwing in walls.
Remove the battery pack (4) from the handle,
pressing the pushlock button (5) downwards to do
so.
Check that your mains voltage is the same as that
marked on the rating plate of the battery charger.
(230V - 240V). Plug the mains plug of the charger
(8) into the mains socket outlet.