Proper Use - Bavaria BCD 18/1 Li Original Operating Instructions

Table of Contents

Advertisement

7.
Do not over-charge batteries. Do not
exceed the maximum charging times. These
charging times only apply to discharged
batteries. Frequent insertion of a charged
or partly charged battery pack will result in
overcharging and cell damage. Do not leave
batteries in the charger for days on end.
8.
Never use or charge batteries if you suspect
that the last time they were charged was
more than 12 months previously. There is
a high probability that the battery pack
has already suffered dangerous damage
(exhaustive discharge).
9.
Charging batteries at a temperature below
10°C will cause chemical damage to the cell
and may cause a fire.
10.
Do not use batteries which have heated
during the charging process, as the battery
cells may have suffered dangerous damage.
11.
Do not use batteries which have suffered
curvature or deformation during the charging
process or which show other non-typical
symptoms (gassing, hissing, cracking,...)
12.
Never fully discharge the battery pack
(recommended depth of discharge max.
80%) A complete discharge of the battery
pack will lead to premature ageing of the
battery cells.
13.
Never charge the batteries unsupervised.
Protection from environmental influences
1.
Wear suitable work clothes. Wear safety
goggles.
2.
Protect your cordless tool and the battery
charger from moisture and rain. Moisture and
rain can cause dangerous cell damage.
3.
Do not use the cordless tool or the battery
charger near vapors and inflammable liquids.
4.
Use the battery charger and cordless tools
only in dry conditions and an ambient
temperature of 10-40°C.
5.
Do not keep the battery charger in places
where the temperature is likely to reach over
40°C. In particular, do not leave the battery
charger in a car that is parked in the sun.
6.
Protect batteries from overheating.
Overloads, over-charging and exposure to
direct sunlight will result in overheating and
cell damage. Never charge or work with
batteries which have been overheated –
replace them immediately if possible.
7.
Storage of batteries, battery chargers and
cordless tools. Store the charger and your
cordless tool only in dry places with an
ambient temperature of 10-40°C. Store your
lithium-ion battery pack in a cool, dry place
at a temperature of 10-20°C. Protect them
from humidity and direct sunlight. Only place
fully charged batteries in storage (charged to
at least 40%).
8.
Prevent the lithium-ion battery pack from
freezing. Battery packs which were stored
below 0°C for more than 60 minutes must be
disposed of.
9.
When handling batteries be aware of
electrostatic discharge: Electrostatic
discharges cause damage of the electronic
protection system and the battery cells.
Avoid electrostatic charging and never touch
the battery poles.
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with
due care. Keep this manual in a safe place, so that
the information is available at all times. If you give
the equipment to any other person, give them
these operating instructions as well.
We accept no liability for damage or accidents
which arise due to non-observance of these
instructions and the safety information.
3. Layout (Fig. 1)
1.
Torque selector
2.
Forward / Reverse switch
3.
ON/OFF switch
4.
Battery pack
5.
Pushlock button
6.
Selector switch for 1st gear or 2nd gear
7.
Keyless chuck
8.
Battery charger
9.
Battery capacity indicator
10.
Switch for battery capacity indicator
11.
LED light

4. Proper use

The tool is designed for tightening and undoing screws,
as well as for drilling in wood, metal and plastic.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufacturer will
be liable for any damage or injuries of any kind caused as
a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
m
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

45.135.82

Table of Contents