Advertisement
4.4.
SETTING HUMIDITY VALUE
4.4.1.
Press the 'HUMIDITY SETTING' button to cycle from 30% to 80% in 5% increments.
4.5.
SETTING DEHUMIDIFYING MODE
4.5.1.
Press the 'DEHUMIDIFY MODE' button to sequentially step through 'Manually Set Dehumidify' mode
'High Dehumidificationn'
4.6.
SETTING FAN SPEED
4.6.1.
The fan has two speeds. Press the 'Fan Speed' button to cycle between 'Low Speed Fan' and 'High Speed Fan'
4.7.
SETTING TIMER FUNCTION
4.7.1.
To set delayed power-off time, once machine is working press the 'TIMER' button to cycle through the range of hours permitted 0 -
24 hours). To set power-on time, pre-select the required time before setting mode.
4.8.
SLEEP FUNCTION
4.8.1.
The 'SLEEP' will cause the display to turn off EXCEPT for the 'Sleep' icon , Water Tank Full icon
4.9.
AIR CLEAN
To run the air cleaning option, press the 'Air Clean' button and the icon will display
4.10.
AUTO-DEFROST
4.10.1.
The unit will automatically defrost when required. The symbol will display on the screen and will switch off once defrosted.
If the ambient temperature is above 24
interleaved with 5 minute defrost cycles. Below 5
4.11.
WATER TANK
4.11.1.
When the water tank is full, the unit will stop working, sound an audible alarm and display the Water Tank Full symbol
4.12.
CHILD LOCK
4.12.1.
To engage the Child Lock rest a finger on the CHILD LOCK button for approximately 5 seconds. Repeat this to unlock unit.
When the child lock is engaged the symbol
4.13.
DRAIN HOSE CONNECTION (WATER OUTLET)
4.13.1.
The drain hose can be permanently connected to the outlet on the rear face of the unit and the unit run dehumidifier continuously.
4.13.2.
Remove water tank and insert the water pipe onto the water outlet.
4.13.3.
Place the other end into a floor drain.
4.13.4.
If the water pipe is not being used, remove the water pipe.
4.13.5.
Whether the water outlet hose is used or not, the water tank must be in position otherwise the dehumidifier will not operate.
4.14.
AIR FILTER
4.14.1.
The filter needs to be cleaned every two weeks for effective operation of the dehumidifier.
4.14.2.
Remove the plug from the mains supply.
4.14.3.
Place finger into the recess on the bottom edge of the filter cover and lift up and remove to allow filter to be removed.
4.14.4.
DO NOT use any liquid to wash the filter. Only dry in direct sunlight. It is recommenced to replace the filter every six months
depending on usage levels.
4.14.5.
Replace in reverse order as above.
5. MAINTENANCE
WARNING: Disconnect from mains supply before attempting any cleaning or maintenance.
‰
5.1.
Use a wet cloth to clean the outside. DO NOT splash water onto the dehumidifier.
5.2.
Clean the inside of the water tank with an antibacterial cleaner every few weeks to avoid the build up of bacteria. The tank has a
water level warning and must be placed in the right position. The dehumidifier will not work if the water level is too high.
6. TROUBLESHOOTING
Dehumidifier does not work:
- Is dehumidifier plugged in
- Check that water tank is in the correct position
- Check that water tank is not full (empty) and that float ball is in correct position
The pipe is frozen:
- The dehumidifier has a defrosting function. The fan keeps working after the compressor stops working. This will solve the problem of
a frozen pipe. When the defrosting device reaches room temperature, the dehumidifier will resume operation.
The dehumidifier 'runs' without dehumidifying:
(The dehumidifier will blow warmer air when it is working properly).
- Power light lights once per second when it is defrosting
- Power light lights for three seconds then goes out for one second or lights for one second then goes out means there is a fault with
the humidity sensor - contact Sealey stockist
The dehumidifier runs as soon as it is switched on:
- Check if the dehumidifier is defrosting. After defrosting the dehumidifier will restart automatically after defrosting.
Dehumidifying capacity is too weak:
- Check if filter net is blocked - clean
- dehumidifying capacity will be weaker if the temperature and humidity levels are too low
- check if air inlet is blocked - clean
Expected humidity takes a long time to be reached:
- check whether doors and windows are open
- check if anything is producing vapour
- check whether the volume of the room is too large
© Jack Sealey Limited
, and 'Drying (clothes) mode'
C no defrosting will occur. Between 23
o
C the unit will not operate except for the air purification mode.
o
is lit.
Original Language Version
.
.
C and 5
C, the unit will operate normally but
o
o
, 'Continuous mode'
.
and Child Lock
.
SDH20.V5
Issue 1
07/04/21
,
.
Advertisement
