Operation From The Supplied Handheld Remote - Channel Master 9521A Owner's Manual

Operation From The Supplied Handheld Remote

1. Install 2 AAA batteries in the handheld remote.
2. Check operation by pressing the POWER button and observing the display. If it does not function,
check for HH1 in power up diagnostic display. If the display is HH2, refer to Appendix A to change.
3. The UP and DOWN controls will move the antenna position (the same as the front panel controls).
Alternatively, a location may be accessed directly using a 3 digit compass location. Example, press
090 for East, 225 for South-West, etc.
4. Programming Preset Locations
This is the most popular mode of operation. 69 preset locations (01 to 69) allow location numbers
to be the same as TV channel numbers if desired.
a. Find best signal using UP and DOWN controls.
b. Decide on a memory location, eg. 27.
c. Press 27 UP 27.
(Locations 01 to 09, eg. 05 may be programmed by either 05 UP 05 or 5 UP 5.)
d. Location is now memorized.
5. Accessing a Preset Location
As an example, to access location 27, press 27. Display will flash "c27", then show compass
bearing while the antenna is moving. It will become steady "c27" when it arrives. (Locations 01 to
09, eg. 05 may be accessed as either 05 or 5).
6. Displaying Memory Locations/Status
From the handheld remote control, press 99 UP. Then observe the display. Each programmed
location is shown, followed by its digital compass location. Additionally settings of power frequency,
handheld, autosync and timeout are shown. A typical display might be:
60H 60 Hz power
HH1 handheld 1
c05
270 compass bearing for c05
c11
090 compass bearing for c11
c17
270 compass bearing for c17
c25
180 compass bearing for c25
SYn
on autosync on
35 35 moves before a resync
to
on timeout on
888 end of diagnostics
7. Deleting Programmed Locations/Reset
Press 91 DOWN from the handheld remote control. CAUTION - Use this command with care as
ALL memory locations will be deleted. This will also set autosync off and timeout on.
5